Heads up: There are no amended sections in this chapter.
The provisions contained in this appendix are not mandatory unless specifically referenced in the adopting ordinance.

User note:

About this chapter: Appendix A provides illustrations for many system layouts covered in some of the previous chapters.


FIGURE A-1 (SECTION 403.1.1)

EXAMPLE OF SOIL-BORING LOCATIONS FOR TWO CONTIGUOUS ABSORPTION AREAS

Note: Bore hole shall be 4 inches to 8 inches larger than the outside diameter of observation well pipe size.

For SI: 1 inch = 25.4 mm, 1 foot = 304.8 mm.

FIGURE A-2 (SECTION 405.2.4)

MONITORING WELL DESIGN

For SI: 1 foot = 304.8 mm.

FIGURE A-3 (SECTION 406.6.7)

DESIGN OF FILLED AREA SYSTEM

For SI: 1 inch = 25.4 mm.

FIGURE A-4 (SECTION 605.7)

OBSERVATION PIPE

For SI: 1 inch = 25.4 mm, 1 foot = 304.8 mm.

FIGURE A-5 (SECTION 703.1)

PRESSURE DISTRIBUTION SYSTEM DESIGN

For SI: 1 inch = 25.4 mm.

FIGURE A-6 (SECTION 903.1)

MOUND USING THREE TRENCHES FOR ABSORPTION AREA

For SI: 1 inch = 25.4 mm.

FIGURE A-7 (SECTION 903.1)

PLAN VIEW OF MOUND USING A BED FOR THE ABSORPTION AREA

For SI: 1 inch = 25.4 mm.

FIGURE A-8 (SECTION 903.1)

CROSS SECTION OF A MOUND SYSTEM USING THREE TRENCHES FOR THE ABSORPTION AREA

For SI: 1 inch = 25.4 mm.

FIGURE A-9 (SECTION 903.1)

CROSS SECTION OF A MOUND SYSTEM USING A BED FOR THE ABSORPTION AREA

Note: Holes located on bottom are equally spaced.

For SI: 1 inch = 25.4 mm.

FIGURE A-10 (SECTION 903.1)

DISTRIBUTION PIPE LAYOUT

UpCodes Premium
Leverage the most sophisticated code compliance platform.
TRY FREE FOR TWO WEEKS VISIT PRICING