- The jurisdiction shall indicate whether requirements for residential buildings, as indicated in Exception 1 to Section 101.3, are applicable by selecting "Yes" or "No" in Table 302.1. Where "Yes" is selected, the provisions of ICC 700 shall apply and the remainder of this code shall not apply.
- Where the jurisdiction requires enhanced energy performance for buildings designed on a performance basis, the jurisdiction shall indicate a zEPI of 46 or less in Table 302.1 for each occupancy required to have enhanced energy performance.
- Where "Yes" or "No" boxes are provided, the jurisdiction shall check the box to indicate "Yes" where that section is to be enforced as a mandatory requirement in the jurisdiction, or "No" where that section is not to be enforced as a mandatory requirement in the jurisdiction.
REQUIREMENTS DETERMINED BY THE JURISDICTION
|Section||Section Title or Description and Directives||Jurisdictional Requirements|
|CHAPTER 1. SCOPE|
|Detached one- and two-family dwellings and multiple single-family dwellings (townhouses) |
not more than three stories in height above grade plane with a separate means
of egress, their accessory structures, and the site or lot upon which these buildings are
located, shall comply with ICC 700.
|Group R-3 residential buildings, their accessory structures, and the site or lot upon which |
these buildings are located, shall comply with ICC 700.
|Group R-2 and R-4 residential buildings four stories or less in height above grade plane, |
their accessory structures, and the site or lot upon which these buildings are located, shall
comply with ICC 700.
|CHAPTER 4. SITE DEVELOPMENT AND LAND USE|
|402.2.1||Flood hazard area preservation, general||Yes||No|
|402.2.2||Flood hazard area preservation, specific||Yes||No|
|402.3||Surface water protection||Yes||No|
|407.4.1||High-occupancy vehicle parking||Yes||No|
|407.4.2||Low-emission, hybrid and electric vehicle parking||Yes||No|
|409.1||Light pollution control||Yes||No|
|CHAPTER 5. MATERIAL RESOURCE CONSERVATION AND EFFICIENCY|
|503.1||Minimum percentage of waste material diverted from landfills|| 50% |
|CHAPTER 6. ENERGY CONSERVATION, EFFICIENCY AND CO2e EMISSION REDUCTION|
|302.1, 302.1.1, 602.1||zEPI of Jurisdictional Choice — The jurisdiction shall indicate a zEPI of 46 or less in each |
occupancy for which it intends to require enhanced energy performance.
|Occupancy: ______ |
|604.1||Automated demand response infrastructure||Yes||No|
|CHAPTER 7. WATER RESOURCE CONSERVATION, QUALITY AND EFFICIENCY|
|702.7||Municipal reclaimed water||Yes||No|
|CHAPTER 8. INDOOR ENVIRONMENTAL QUALITY AND COMFORT|
|804.2||Post-Construction Pre-Occupancy Baseline IAQ Testing||Yes||No|
|807.1||Sound transmission and sound levels||Yes||No|
|CHAPTER 10. EXISTING BUILDINGS|
|1007.2||Evaluation of existing buildings||Yes||No|
|1007.3||Post Certificate of Occupancy zEPI, energy demand, and CO2e emissions reporting||Yes||No|
Exception: Buildings less than 25,000 square feet (2323 m2) in total building floor area pursuing compliance on a prescriptive basis shall be deemed to have a zEPI of 51 and shall not be required to comply with the zEPI of Jurisdictional Choice indicated by the jurisdiction in Table 302.1.
- The assessment shall demonstrate that the building project achieves not less than a 20-percent improvement in environmental performance for global warming potential and at least two of the following impact measures, as compared to a reference design of similar usable floor area, function and configuration that meets the minimum energy requirements of this code and the structural requirements of the International Building Code. For relocatable buildings, the reference design shall be comprised of the number of reference buildings equal to the estimated number of uses of the relocatable building.
- Primary energy use.
- Acidification potential.
- Eutrophication potential.
- Ozone depletion potential.
- Smog potential.
- The reference and project buildings shall utilize the same life cycle assessment tool.
- The life cycle assessment tool shall be approved by the code official.
- Building operational energy shall be included. For relocatable buildings, an average building operational energy shall be estimated to reflect potential changes in location, siting, and configuration by adding or subtracting modules, or function.
- Building process loads shall be permitted to be included.
- Maintenance and replacement schedules and actions for components shall be included in the assessment. For relocatable buildings, average transportation energy, material and waste generation associated with reuse of relocatable buildings shall be included in the assessment.
- The full life cycle, from resource extraction to demolition and disposal, including but not limited to, onsite construction, maintenance and replacement, relocation and reconfiguration, and material and product embodied acquisition, process and transportation energy, shall be assessed.
- The complete building envelope, structural elements, inclusive of footings and foundations, and interior walls, floors and ceilings, including interior and exterior finishes, shall be assessed to the extent that data are available for the materials being analyzed in the selected life cycle assessment tool.
- The life cycle assessment shall conform to the requirements of ISO 14044.