The standards listed in Table 1701.1 are intended for use in the design, testing, and installation of materials, devices, appliances, and equipment regulated by this code. These standards are mandatory where required by sections in this code.

    Organization abbreviations referred to in Table 1701.1 are defined in a list found at the end of the table.

TABLE 1701.1
REFERENCED STANDARDS
*   ANSI designated as an American National Standard.
Italic/Bold referenced standards indicate where such standards are located in the narrative of the code.

Notes:
1 Although these standards are referenced in Chapter 17, some of the materials and equipment in the standards are not acceptable for use under the provisions of this code.
2 See Section 1211.3 for restrictions.


ABBREVIATIONS IN TABLE 1701.1

AABC Associated Air Balance Council, 1518 K Street NW, Suite 503, Washington, DC 20005.
ACCA Air Conditioning Contractors of America Association, Inc., 2800 S Shirlington Road, Suite 300, Arlington, VA 22206.
AHRI Air-Conditioning, Heating, and Refrigeration Institute, 2111 Wilson Boulevard, Suite 500, Arlington, VA 22201.
AMCA Air Movement and Control Association, 30 West University Drive, Arlington Heights, IL 60004-1806.
ANSI American National Standards Institute, Inc., 25 W. 43rd Street, 4th Floor, New York, NY 10036.
ASCE American Society of Civil Engineers, 1801 Alexander Bell Drive, Reston, VA 20191-4400.
ASHRAE American Society of Heating, Refrigerating, and Air Conditioning Engineers, Inc., 1791 Tullie Circle, NE, Atlanta, GA 30329-2305.
ASMI American Society of Mechanical Engineering, Two Park Avenue, New York, NY 10016-5990.
ASSE American Society of Sanitary Engineering, 18927 Hickory Creek Drive, Suite 220, Mokena, IL 60448.
ASTM ASTM International, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959.
AWS American Welding Society, 8669 NW 36 Street, #130, Miami, FL 33166-6672.
AWWA American Water Works Association, 6666 W. Quincy Avenue, Denver, CO 80235.
CGSB Canadian General Standards Board, 11 Laurier Street, Phase III, Place du Portage, 6B1, Gatineau, Quebec, Canada K1A 0S5.
CGA Compressed Gas Association, 14501 George Carter Way, Suite 103, Chantilly, VA 20151.
CSA Canadian Standards Association, 5060 Spectrum Way, Suite 100, Mississauga, Ontario, Canada, L4W 5N6.
e1 An editorial change since the last revision or reapproval.
IAPMO International Association of Plumbing and Mechanical Officials, 5001 E. Philadelphia Street, Ontario, CA 91761.
IAS International Approval Service, A Division of CSA, 8501 East Pleasant Valley Road, Cleveland, OH 44131.
IIAR International Institute of Ammonia Refrigeration, 1001 N. Fairfax Street, Suite 503, Alexandria, VA 22314.
ISO International Organization for Standardization, 1 ch. de la Voie-Creuse, Casa Postale 56, CH-1211 Geneva 20, Switzerland.
MSS Manufacturers Standardization Society of the Valve and Fittings Industry, 127 Park Street NE, Vienna, VA 22180.
NEBB NEBB, 8575 Grovemont Circle, Gaithersburg, MD 20877.
NFPA National Fire Protection Association, 1 Batterymarch Park, Quincy, MA 02169-7471.
NSF NSF International, 789 N. Dixboro Road, Ann Arbor, MI 48105.
PPI Plastic Pipe Institute, 105 Decker Court, Suite 825, Irving, TX 75062.
SAE Society of Automotive Engineers, 400 Commonwealth Drive, Warrendale, PA 15096.
SMACNA Sheet Metal and Air Conditioning Contractors National Association, 4201 Lafayette Center Drive, Chantilly, VA 20151-1219.
UL Underwriters Laboratories, Inc., 333 Pfingsten Road, Northbrook, IL 60062.
Resources