// CODE SNIPPET
1926.754(c) Walking/Working Surfaces -- Shear Connectors and Other Similar Devices
JUMP TO FULL CODE CHAPTER
Shear connectors (such as headed steel studs, steel bars or steel lugs), reinforcing bars, deformed anchors or threaded studs shall not be attached to the top flanges of beams, joists or beam attachments so that they project vertically from or horizontally across the top flange of the member until after the metal decking, or other walking/working surface, has been installed.
When shear connectors are used in construction of composite floors, roofs and bridge decks, employees shall lay out and install the shear connectors after the metal decking has been installed, using the metal decking as a working platform. Shear connectorshall not be installed from within a controlled decking zone (CDZ), as specified in § 1926.760(c)(8).
Related Code Sections
1926.754(c) Steel Erection, Walking/Working Surfaces -- Shear Connectors and Other Similar Devices
after the metal decking, or other walking/working surface, has been installed ...
OSHA 1926 Construction > R Steel Erection > 1926.754 Structural Steel Assembly > 1926.754(c) Walking/Working Surfaces -- Shear Connectors and Other Similar Devices
1926.751 Steel Erection, Definitions
or other walking/working surface. Pre-engineered holes in cellular decking (for wires, cables, etc.) are not included in this definition. Derrick ...
1926.500(b) Fall Protection, Definitions
dimension, in a floor, roof, or other walking/working surface. Infeasible means that it is impossible to perform the construction work using ...
OSHA 1926 Construction > M Fall Protection > 1926.500 Scope, Application, and Definitions Applicable to This Subpart > 1926.500(b) Definitions
1926.605(c) Motor Vehicles, Mechanized Equipment, and Marine Operations, Working Surfaces of Barges
Decks and other working surfaces shall be maintained in a safe condition ...
OSHA 1926 Construction > O Motor Vehicles, Mechanized Equipment, and Marine Operations > 1926.605 Marine Operations and Equipment > 1926.605(c) Working Surfaces of Barges