// CODE SNIPPET
(C) Voltage and Temperature Ratings
JUMP TO FULL CODE CHAPTER
The cable shall have a voltage rating of not less than 300 volts. The cable shall have a temperature rating of not less than 60°C (140 °F).
Related Code Sections
(C) Special Conditions, Voltage and Temperature Ratings
The cable shall have a voltage rating of not less than 300 volts. The cable shall have a temperature rating of not less than 60°C (140 °F) ...
National Electrical Code 2020 of Minnesota > 7 Special Conditions > 760 Fire Alarm Systems > 760.179 Listing and Marking of PLFA Cables and Insulated Continuous Line-Type Fire Detectors > (C) Voltage and Temperature Ratings
(G) Special Conditions, Class 2 and Class 3 Cable Voltage and Temperature Ratings
Class 2 cables shall have a voltage rating of not less than 150 volts. Class 3 cables shall have a voltage rating of not less than 300 volts. Class 2 ...
National Electrical Code 2020 of Minnesota > 7 Special Conditions > 725 Class 1, Class 2, and Class 3 Remote- Control, Signaling, and Power-Limited Circuits > 725.179 Listing and Marking of Class 2, Class 3, and Type PLTC Cables > (G) Class 2 and Class 3 Cable Voltage and Temperature Ratings
368.320 Wiring Methods and Materials, Marking
Each busway run shall be provided with a permanent nameplate on which the following information shall be provided: Rated voltage. Rated ...
National Electrical Code 2020 of Minnesota > 3 Wiring Methods and Materials > (2)Floors > 368.320 Marking
(A) Special Equipment, Photovoltaic Source and Output Circuits
the rated open-circuit voltage by the appropriate correction factor shown below.) Ambient Temperature (°C) Factor Ambient Temperature (°F ...
National Electrical Code 2020 of Minnesota > 6 Special Equipment > 690 Solar Photovoltaic (PV) Systems > 690.7 Maximum Voltage > (A) Photovoltaic Source and Output Circuits
26.2.7 Supervising Station Alarm Systems, Supervising Station Signal Processing Equipment
, humidity, and voltage rating range of the equipment, and the equipment manufacturer's published instructions are available for examination ...
National Fire Alarm and Signaling Code 2016 of Minnesota > 26 Supervising Station Alarm Systems > 26.2 General > 26.2.7 Supervising Station Signal Processing Equipment