// CODE SNIPPET
804.3.5 Vertical Terminations
JUMP TO FULL CODE CHAPTER
Vertical terminations shall comply with the following requirements:
- Where located adjacent to walkways, the termination of mechanical draft systems shall be not less than 7 feet (2134 mm) above the level of the walkway.
- Vents shall terminate not less than 3 feet (914 mm) above any forced air inlet located within 10 feet (3048 mm) horizontally.
- Where the vent termination is located below an adjacent roof structure, the termination point shall be located not less than 3 feet (914 mm) from such structure.
- The vent shall terminate not less than 4 feet (1219 mm) below, 4 feet (1219 mm) horizontally from or 1 foot (305 mm) above any door, window or gravity air inlet for the building.
- A vent cap shall be installed to prevent rain from entering the vent system.
- The vent termination shall be located not less than 3 feet (914 mm) horizontally from any portion of the roof structure.
Related Code Sections
804.3.5 Chimneys and Vents, Vertical Terminations
Vertical terminations shall comply with the following requirements: Where located adjacent to walkways, the termination of mechanical draft systems ...
Ohio Mechanical Code 2017 > 8 Chimneys and Vents > 804 Direct-Vent, Integral Vent and Mechanical Draft Systems > 804.3 Mechanical Draft Systems > 804.3.5 Vertical Terminations
804.3.5 Chimneys and Vents, Vertical Terminations
Vertical terminations shall comply with the following requirements: Where located adjacent to walkways, the termination of mechanical draft systems ...
Ohio Mechanical Code 2011 > 8 Chimneys and Vents > 804 Direct-Vent, Integral Vent Andmechanical Draft Systems > 804.3 Mechanical Draft Systems > 804.3.5 Vertical Terminations
2427.6.4 Fuel Gas, Minimum Height
A Type B or L gas vent shall terminate at least 5 feet (1524 mm) in vertical height above the highest connected appliance draft hood or flue collar ...
Ohio Residential Code 2013 > 24 Fuel Gas > 2427 Venting of Appliances > 2427.6 Gas Vents > 2427.6.4 Minimum Height
(3) Equipment for General Use, Same Vertical Section
Other than the required interconnections and control wiring, only those conductors that are intended for termination in a vertical section ...
National Electrical Code, 2017 > 4 Equipment for General Use > 408 Switchboards, Switchgear, and Panelboards > 408.3 Support and Arrangement of Busbars and Conductors > (A) Conductors and Busbars on a Switchboard, Switchgear, or Panelboard > (3) Same Vertical Section
(A) Equipment for General Use, Support and Arrangement
conductors that are intended for termination in a vertical section shall be located in that section. Exception: Conductors shall be permitted ...
National Electrical Code, 2017 > 4 Equipment for General Use > 430 Motors, Motor Circuits, and Controllers > 430.97 Busbars and Conductors > (A) Support and Arrangement