// CODE SNIPPET
1910.255(d)(1) Ventilation and Flash Guard
JUMP TO FULL CODE CHAPTER
Flash welding machines shall be equipped with a hood to control flying flash. In cases of high production, where materials may contain a film of oil and where toxic elements and metal fumes are given off, ventilation shall be provided in accordance with 1910.252(c) of this section.
Related Code Sections
1910.255(d)(1) Welding, Cutting, and Brazing, Ventilation and Flash Guard
Flash welding machines shall be equipped with a hood to control flying flash. In cases of high production, where materials may contain a film of oil ...
OSHA 1910 General Industry > Q Welding, Cutting, and Brazing > 1910.255 Resistance Welding > 1910.255(d) Flash Welding Equipment > 1910.255(d)(1) Ventilation and Flash Guard
1910.211(d)(32) Machinery and Machine Guarding, Guard
Guard means a barrier that prevents entry of the operator's hands or fingers into the point of operation ...
OSHA 1910 General Industry > O Machinery and Machine Guarding > 1910.211 Definitions > 1910.211(d) > 1910.211(d)(32) Guard
1910.68(b)(10)(iv) Powered Platforms, Manlifts, and Vehicle-Mounted Work Platforms, Guardrails
To guard against persons walking under a descending step, the area on the downside of the manlift shall be guarded in accordance with subparagraph (8 ...
OSHA 1910 General Industry > F Powered Platforms, Manlifts, and Vehicle-Mounted Work Platforms > 1910.68 Manlifts > 1910.68(b) General Requirements > 1910.68(b)(10) Bottom Arrangement > 1910.68(b)(10)(iv) Guardrails
1910.178(q)(10) Materials Handling and Storage,
Low flash point (below 100 °F.) solvents shall not be used. High flash point (at or above 100 °F.) solvents may be used. Precautions regarding ...
OSHA 1910 General Industry > N Materials Handling and Storage > 1910.178 Powered Industrial Trucks > 1910.178(q) Maintenance of Industrial Trucks > 1910.178(q)(10)
1910.215(a)(2) Machinery and Machine Guarding, Guard Design
The safety guard shall cover the spindle end, nut, and flange projections. The safety guard shall be mounted so as to maintain proper alignment ...
OSHA 1910 General Industry > O Machinery and Machine Guarding > 1910.215 Abrasive Wheel Machinery > 1910.215(a) General Requirements > 1910.215(a)(2) Guard Design