// CODE SNIPPET
M2105.24 Velocities
JUMP TO FULL CODE CHAPTER
Ground-source heat-pump ground-loop systems shall be designed so that the flow velocities do not exceed the maximum flow velocity recommended by the pipe and fittings manufacturer. Flow velocities shall be controlled to reduce the possibility of water hammer.
Related Code Sections
1210.8.8 Hydronic Piping, Velocities
Ground-source heat pump ground-loop systems shall be designed so that the flow velocities do not exceed the maximum flow velocity recommended ...
Mechanical Code 2018 of Kansas > 12 Hydronic Piping > 1210 Plastic Pipe Ground-Source Heat Pump Loop Systems > 1210.8 Installation > 1210.8.8 Velocities
M2105.24 Hydronic Piping, Velocities
Ground-source heat-pump ground-loop systems shall be designed so that the flow velocities do not exceed the maximum flow velocity recommended ...
Residential Code 2018 of Kansas > 21 Hydronic Piping > M2105 Ground-Source Heat-Pump System Loop Piping > M2105.24 Velocities
2404.7.3 Flammable Finishes, Air Velocity
be provided with mechanical ventilation so that the average air velocity through openings is in accordance with Sections 2404.7.3.1 and 2404.7.3.2 ...
Fire Code 2018 of Kansas > 24 Flammable Finishes > 2404 Spray Finishing > 2404.7 Ventilation > 2404.7.3 Air Velocity
502.7.3.3 Exhaust Systems, Air Velocity
be provided with mechanical ventilation so that the average air velocity through openings is in accordance with Sections 502.7.3.3.1 and 502.7.3.3.2 ...
Mechanical Code 2018 of Kansas > 5 Exhaust Systems > 502 Required Systems > 502.7 Application of Flammable Finishes > 502.7.3 Flammable Vapor Areas > 502.7.3.3 Air Velocity
506.3.4 Exhaust Systems, Air Velocity
Grease duct systems serving a Type I hood shall be designed and installed to provide an air velocity within the duct system of not less than 500 feet ...
Mechanical Code 2018 of Kansas > 5 Exhaust Systems > 506 Commercial Kitchen Hood Ventilation System Ducts and Exhaust Equipment > 506.3 Ducts Serving Type I Hoods > 506.3.4 Air Velocity