// CODE SNIPPET
P3007.2 Valves Required
JUMP TO FULL CODE CHAPTER
A check valve and a full open valve located on the discharge side of the check valve shall be installed in the pump or ejector discharge piping between the pump or ejector and the gravity drainage system. Access shall be provided to such valves. Such valves shall be located above the sump cover required by Section P3007.3.2 or, where the discharge pipe from the ejector is below grade, the valves shall be accessibly located outside the sump below grade in an access pit with a removable access cover.
Related Code Sections
712.2 Sanitary Drainage, Valves Required
required by Section 712.1 or, where the discharge pipe from the ejector is below grade, the valves shall be accessibly located outside the sump below ...
P2903.9.4 Water Supply and Distribution, Valve Requirements
P2903.9.4 or shall be approved . Valves intended to supply drinking water shall meet the requirements of NSF 61.
TABLE P2903.9.4
VALVES ...
Residential Code 2018 of Kansas > 29 Water Supply and Distribution > P2903 Water Supply System > P2903.9 Valves > P2903.9.4 Valve Requirements
P3007.2 Sanitary Drainage, Valves Required
required by Section P3007.3.2 or, where the discharge pipe from the ejector is below grade, the valves shall be accessibly located outside the sump ...
Residential Code 2018 of Kansas > 30 Sanitary Drainage > P3007 Sumps and Ejectors > P3007.2 Valves Required
P2804.1 Water Heaters, Relief Valves Required
Appliances and equipment used for heating water or storing hot water shall be protected by one of the following: A separate pressure-relief valve ...
Residential Code 2018 of Kansas > 28 Water Heaters > P2804 Relief Valves > P2804.1 Relief Valves Required
6.6.1.1 System Components and Hardware, Valve Pressure Requirements
When water pressures exceed 175 psi (12 bar), valves shall be used in accordance with their pressure ratings ...
Standard for the Installation of Sprinkler Systems 2016 of Kansas > 6 System Components and Hardware > 6.6 Valves > 6.6.1 General > 6.6.1.1 Valve Pressure Requirements