// CODE SNIPPET
2107.2 TMS 402/ACI 530/ASCE 5, Section 220.127.116.11.1.1, Lap Splices
JUMP TO FULL CODE CHAPTER
In lieu of Section 18.104.22.168.1.1, it shall be permitted to design lap splices in accordance with Section 2107.2.1.
The minimum length of lap splices for reinforcing bars in tension or compression, ld, shall be
|ld = 0.002dbfs||(Equation 21-1)|
For SI: ld= 0.29dbfs
but not less than 12 inches (305 mm). In no case shall the length of the lapped splice be less than 40 bar diameters.
|db||=||Diameter of reinforcement, inches (mm).|
|fs||=||Computed stress in reinforcement due to design loads, psi (MPa).|
In regions of moment where the design tensile stresses in the reinforcement are greater than 80 percent of the allowable steel tension stress, Fs, the lap length of splices shall be increased not less than 50 percent of the minimum required length. Other equivalent means of stress transfer to accomplish the same 50 percent increase shall be permitted. Where epoxy coated bars are used, lap length shall be increased by 50 percent.
Related Code Sections
2107.2.1 Masonry, Lap Splices
The minimum length of lap splices for reinforcing bars in tension or compression, l d , shall be l d = 0.002 d b f s (Equation 21-1 ...
Building Code 2012 of South Holland, IL > 21 Masonry > 2107 Allowable Stress Design > 2107.2 TMS 402/ACI 530/ASCE 5, Section 22.214.171.124.1.1, Lap Splices > 2107.2.1 Lap Splices
2109.1 Masonry, General
Empirically designed masonry shall conform to the requirements of Chapter 5 of TMS 402/ACI 530/ASCE 5, except where otherwise noted in this section ...
Building Code 2012 of South Holland, IL > 21 Masonry > 2109 Empirical Design of Masonry > 2109.1 General
2101.2 Masonry, Design Methods
) masonry shall comply with the provisions of Section 2106 and Chapters 1 and 8 of TMS 402/ACI 530/ASCE 5 ...
1405.6 Exterior Walls, Anchored Masonry Veneer
to the requirements of Section 126.96.36.199 of TMS 402/ACI 530/ASCE 5 ...
Building Code 2012 of South Holland, IL > 14 Exterior Walls > 1405 Installation of Wall Coverings > 1405.6 Anchored Masonry Veneer
R606.1 Wall Construction, General
design provisions of Chapter 5 of TMS 402/ACI 530/ASCE 5, the provisions of TMS 403, or the provisions of this section are used to design masonry ...
Residential Code 2012 of South Holland, IL > 6 Wall Construction > R606 General Masonry Construction > R606.1 General