// CODE SNIPPET
1318.9.1 Time Frame for Testing
JUMP TO FULL CODE CHAPTER
Tests shall be conducted after the final installation of station outlet valve bodies, faceplates, and other distribution system components (e.g. pressure alarm devices, pressure indicators, line pressure relief valves, manufactured assemblies, hose). [NFPA 99:5.1.12.2.6.1]
Related Code Sections
1318.9.1 Health Care Facilities and Medical Gas and Medical Vacuum Systems, Time Frame for Testing
Tests shall be conducted after the final installation of station outlet valve bodies, faceplates, and other distribution system components (e.g ...
2018 Uniform Plumbing Code of Nevada > 13 Health Care Facilities and Medical Gas and Medical Vacuum Systems > 1318.0 Testing and Inspection > 1318.9 Standing Pressure Tests — For Positive Pressure Medical Gas Piping Systems > 1318.9.1 Time Frame for Testing
A9.3.2 Normative Appendix A Rated R-Value of Insulation and Assembly U-factor, C-Factor, and F-Factor Determinations, Assembly U-Factors
material or representative of material as purchased by the consumer or contractor. If the assembly is too large to be tested at one time in its entirety ...
Energy Standard for Buildings Except Low-Rise Residential Buildings 2016 of Nevada > Normative Appendix A Rated R-Value of Insulation and Assembly U-factor, C-Factor, and F-Factor Determinations > A9 Determination of Alternate Assembly U-Factors, C-Factors, F-Factors, or Heat Capacities > A9.3 Testing Procedures > A9.3.2 Assembly U-Factors
Section 1710 Special Inspections and Tests, Preconstruction Load Tests
The test assembly shall be subjected to an increasing superimposed load equal to not less than two times the superimposed design load ...
Section 1709 Special Inspections and Tests, Preconstruction Load Tests
equal to not less than two times the superimposed design load. The test load shall be left in place for a period of 24 hours. The tested assembly ...
Section R612 Wall Construction, Exterior Windows and Doors
assemblies to be supported without exceeding the appropriate material stress levels. If tested by an approved laboratory, the 1.5 times the design ...