// CODE SNIPPET
Section A505 Tier 1 Analysis Procedure
JUMP TO FULL CODE CHAPTER
Structures conforming to the requirements of the ASCE 41 Chapter 4, Screening Phase, are permitted to be shown to be in conformance to this chapter by submission of a report to the building official, as described in this section.
The registered design professional shall prepare a report summarizing the analysis conducted in compliance with this section. As a minimum, the report shall include the following items:
- Building description.
- Site inspection summary.
- Summary of reviewed record documents.
- Earthquake design data used for the evaluation of the building.
- Completed checklists.
- Quick-check analysis calculations.
- Summary of deficiencies.
Related Code Sections
Section A505 Earthquake Hazard Reduction in Existing Concrete Buildings, Tier 1 Analysis Procedure
The registered design professional shall prepare a report summarizing the analysis conducted in compliance ...
Existing Building Code 2015 of Idaho > A5 Earthquake Hazard Reduction in Existing Concrete Buildings > A505 Tier 1 Analysis Procedure
A506.1 Earthquake Hazard Reduction in Existing Concrete Buildings, General
deficiencies identified in Tier 1, using procedures specified in this section. If a Tier 2 analysis identifies a nonconforming condition ...
Existing Building Code 2015 of Idaho > A5 Earthquake Hazard Reduction in Existing Concrete Buildings > A506 Tier 2 Analysis Procedure > A506.1 General
A506.3.1 Earthquake Hazard Reduction in Existing Concrete Buildings, Mathematical Model
members and the floor above.
Cast-in-place reinforced concrete floors with span-todepth ratios less than three-to-one may be assumed to be rigid ...
Existing Building Code 2015 of Idaho > A5 Earthquake Hazard Reduction in Existing Concrete Buildings > A506 Tier 2 Analysis Procedure > A506.3 Analysis Procedure > A506.3.1 Mathematical Model
301.1.4 Provisions for All Compliance Methods, Seismic Evaluation and Design Procedures
" system.
ASCE 41, using a Tier 3 procedure and the two-level performance objective in Table 301.1.4.1 for the applicable risk category.
[BS ...
Existing Building Code 2015 of Idaho > 3 Provisions for All Compliance Methods > 301 Administration > 301.1 General > 301.1.4 Seismic Evaluation and Design Procedures
303.3 Provisions for All Compliance Methods, Seismic Evaluation and Design Procedures
, II and III, the Tier 1 and Tier 2 procedures need not be considered for the BSE-1E earthquake hazard level. For Risk Category III, the Tier 1 ...
Existing Building Code 2018 of Idaho > 3 Provisions for All Compliance Methods > 303 Structural Design Loads and Evaluation and Design Procedures > 303.3 Seismic Evaluation and Design Procedures