// CODE SNIPPET
1910.305(a)(2)(iv) The Following Requirements Apply to Feeders:
JUMP TO FULL CODE CHAPTER
Feeders shall originate in an approved distribution center.
Conductors shall be run as multiconductor cord or cable assemblies. However, if installed as permitted in paragraph (a)(2)(i)(C) of this section, and if accessible only to qualified persons, feeders may be run as single insulated conductors.
Related Code Sections
1910.305(a)(2)(iv) Electrical, The Following Requirements Apply to Feeders:
Feeders shall originate in an approved distribution center ...
OSHA 1910 General Industry > S Electrical > 1910.305 Wiring Methods, Components, and Equipment for General Use > 1910.305(a) Wiring Methods > 1910.305(a)(2) Temporary Wiring > 1910.305(a)(2)(iv) The Following Requirements Apply to Feeders:
1910.304(f)(2)(iv) Electrical, The Following Additional Requirements Apply to Feeders Only:
The continuous ampere rating of a fuse may not exceed three times the ampacity of the conductors. The long-time trip element setting of a breaker ...
OSHA 1910 General Industry > S Electrical > 1910.304 Wiring Design and Protection > 1910.304(f) Overcurrent Protection > 1910.304(f)(2) Feeders and Branch Circuits Over 600 Volts, Nominal > 1910.304(f)(2)(iv) The Following Additional Requirements Apply to Feeders Only:
1910.304(f) Electrical, Overcurrent Protection
The following requirements apply to overcurrent protection of circuits rated 600 volts, nominal, or less ...
OSHA 1910 General Industry > S Electrical > 1910.304 Wiring Design and Protection > 1910.304(f) Overcurrent Protection
1910.304(c) Electrical, Outside Conductors, 600 Volts, Nominal, or Less
The following requirements apply to branch-circuit, feeder, and service conductors rated 600 volts, nominal, or less and run outdoors as open ...
OSHA 1910 General Industry > S Electrical > 1910.304 Wiring Design and Protection > 1910.304(c) Outside Conductors, 600 Volts, Nominal, or Less
1910.304 Electrical, Wiring Design and Protection
The following requirements apply to branch-circuit, feeder, and service ...