// CODE SNIPPET
Section P2703 Tail Pieces
Related Code Sections
Section P2703 Plumbing Fixtures, Tail Pieces
Fixture tail pieces shall be not less than 1 1 / 2 inches (38 mm) in diameter for sinks, dishwashers, laundry tubs, bathtubs and similar fixtures ...
1609.5.3 Structural Design, Rigid Tile
at 0.76L from the head of the tile and the middle of the exposed width. For roof tiles with nails or screws (with or without a tail clip), the axis ...
Building Code 2018 of Kansas > 16 Structural Design > 1609 Wind Loads > 1609.5 Roof Systems > 1609.5.3 Rigid Tile
2304.9.2.4 Wood, Cantilevered Pieces Intermixed Pattern
The decking shall extend across not fewer than three spans. Pieces in each starter course and every third course shall be simple span pattern. Pieces ...
Building Code 2018 of Kansas > 23 Wood > 2304 General Construction Requirements > 2304.9 Lumber Decking > 2304.9.2 Layup Patterns > 2304.9.2.4 Cantilevered Pieces Intermixed Pattern
(A) Special Equipment, General
to the premises grounding and bonding system. Attached metal parts, such as turbine blades and tails that are not likely to become energized, shall ...
National Electrical Code 2017 of Kansas > 6 Special Equipment > 694 Wind Electric Systems > 694.40 Equipment Grounding and Bonding > (A) General
2006.3.1.1 Aviation Facilities, Internal Combustion Type
capacity shall not exceed 5 gallons (19 L) where the tank is installed on the engine. The exhaust pipe, muffler and tail pipe shall be shielded ...
Fire Code 2018 of Kansas > 20 Aviation Facilities > 2006 Aircraft Fueling > 2006.3 Construction of Aircraft-Fueling Vehicles and Accessories > 2006.3.1 Transfer Apparatus > 2006.3.1.1 Internal Combustion Type