// CODE SNIPPET
Section P3303 Sumps and Pumping Systems
JUMP TO FULL CODE CHAPTER
The sump pump shall be of a capacity and head appropriate to anticipated use requirements.
The sump shall be not less than 18 inches (457 mm) in diameter and 24 inches (610 mm) deep, unless otherwise approved. The sump shall be accessible and located so that all drainage flows into the sump by gravity. The sump shall be constructed of tile, steel, plastic, cast iron, concrete or other approved material, with a removable cover adequate to support anticipated loads in the area of use. The sump floor shall be solid and provide permanent support for the pump.
Related Code Sections
Section 1113 Storm Drainage, Sumps and Pumping Systems
The sump pump, pit and discharge piping shall conform to Sections 1113.1.1 through 1113.1.4 ...
Section P3303 Storm Drainage, Sumps and Pumping Systems
The sump pump, sump and discharge piping shall conform to Sections P3303.1.1 through P3303.1.4 ...
P3303.1.1 Storm Drainage, Pump Capacity and Head
The sump pump shall be of a capacity and head appropriate to anticipated use requirements ...
Residential Code 2018 of Kansas > 33 Storm Drainage > P3303 Sumps and Pumping Systems > P3303.1 Pumping System > P3303.1.1 Pump Capacity and Head
1113.1.3 Storm Drainage, Electrical
Electrical service outlets, where required, shall meet the requirements of NFPA 70 ...
Plumbing Code 2018 of Kansas > 11 Storm Drainage > 1113 Sumps and Pumping Systems > 1113.1 Pumping System > 1113.1.3 Electrical
1113.1.4 Storm Drainage, Piping
and fittings shall be the same size as, or larger than, the pump discharge tapping. Exception: In one- and two-family dwellings, only a check valve ...
Plumbing Code 2018 of Kansas > 11 Storm Drainage > 1113 Sumps and Pumping Systems > 1113.1 Pumping System > 1113.1.4 Piping