UpCodes logo
Jump To Full Code Chapter
Sprinkler heads installed in spraying spaces shall be protected in an approved manner from accumulation of residue from spraying operations. Sprinkler heads shall be inspected at least once per week and cleaned as needed. Bags used as a protective covering shall be of 0.003-inch-thick (0.076-mm-thick) polyethylene or cellophane or shall be of thin paper. Sprinkler heads contaminated by overspray particles shall be replaced with new sprinkler heads.

Related Code Sections

§27-966 Fire Alarm, Detection and Extinguishing Equipment, Protection of Sprinkler System
be subject to the requirements of the health department and the bureau of water supply of the department of environmental protection. (b) Sprinkler heads ...
508.1 General Building Heights and Areas; Separation of Occupancies, General
Additionally, sprinkler heads protecting the opening between the cooking facilities and the dining spaces shall be located within 24 inches (609 mm ...
22.7.2 Special Occupancy Requirements, Installation Requirements
In areas or rooms where nitrate film is handled, the area that is protected per sprinkler head shall not exceed 64 ft2 (6 m2) with sprinklers ...
710.2 Fire and Smoke Protection Features, Materials
and shall otherwise comply with Chapter 24, and shall be protected by sprinkler heads installed in a maximum of 6 feet (1828.8 mm) on center on each ...
711.2 Fire and Smoke Protection Features, Materials
and shall otherwise comply with Chapter 24, and shall be protected by sprinkler heads installed in a maximum of 6 feet (1829 mm) on center on each ...