// CODE SNIPPET
312.7 Space in Enclosures
Related Code Sections
312.7 Wiring Methods and Materials, Space in Enclosures
Cabinets and cutout boxes shall have approved space to accommodate all conductors installed in them without crowding ...
National Electrical Code 2020 of Minnesota > 3 Wiring Methods and Materials > 312 Cabinets, Cutout Boxes, and Meter Socket Enclosures > 312.7 Space in Enclosures
430.10 Equipment for General Use, Wiring Space in Enclosures
Minimum wirebending space within the enclosures for motor controllers shall be in accordance with Table 430.10(B) where measured in a straight line from ...
National Electrical Code 2020 of Minnesota > 4 Equipment for General Use > 430 Motors, Motor Circuits, and Controllers > 430.10 Wiring Space in Enclosures
408.55 Equipment for General Use, Wire-Bending Space Within an Enclosure Containing a Panelboard
The enclosure for a panelboard shall have the top and bottom wire-bending space sized in accordance with Table 312.6(B) for the largest conductor ...
National Electrical Code 2020 of Minnesota > 4 Equipment for General Use > 408 Switchboards, Switchgear, and Panelboards > 408.55 Wire-Bending Space Within an Enclosure Containing a Panelboard
(2) Special Equipment, Installation
(a) Vertical Spacing . The enclosure shall be located not less than 100 mm (4 in.), measured from the inside of the bottom of the box, above ...
National Electrical Code 2020 of Minnesota > 6 Special Equipment > 680 Swimming Pools, Fountains, and Similar Installations > 680.24 Junction Boxes and Electrical Enclosures for Transformers or Ground-Fault Circuit Interrupters > (B) Other Enclosures > (2) Installation