// CODE SNIPPET
1126A.7 Smooth Surface
JUMP TO FULL CODE CHAPTER
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door or gate. Parts creating horizontal or vertical joints in these surfaces shall be within 1/16 inch (1.6 mm) of the same plane as the other and be free of sharp or abrasive edges. Cavities created by added kick plates shall be capped.
Exceptions:
- Automatic doors or gates.
- Tempered glass doors without stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal.
- Doors or gates that do not extend to within 10 inches (254 mm) of the finish floor or ground.
Related Code Sections
1126A.7 Housing Accessibility, Smooth Surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push ...
California Building Code 2016 (Vol 1 & 2) > 11A Housing Accessibility > 1126A Doors, Gates and Windows > 1126A.7 Smooth Surface
1132A.9 Housing Accessibility, Smooth Surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push ...
California Building Code 2016 (Vol 1 & 2) > 11A Housing Accessibility > 1132A Doors > 1132A.9 Smooth Surface
11B-404.2.10 Accessibility to Public Buildings, Public Accommodations, Commercial Buildings and Public Housing, Door and Gate Surfaces
Swinging door and gate surfaces within 10 inches ( 254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push ...
California Building Code 2016 (Vol 1 & 2) > 11B Accessibility to Public Buildings, Public Accommodations, Commercial Buildings and Public Housing > 11B-404 Doors, Doorways, and Gates > 11B-404.2 Manual Doors, Doorways, and Manual Gates > 11B-404.2.10 Door and Gate Surfaces
Section 21.804 Referenced Standards, — Packing
in layers not exceeding 1 / 4 inch (6.4 mm) in depth until it is filled; then it shall be tooled to a smooth surface to match the original profile ...
California Existing Building Code 2016 > Referenced Standards > 21-8 Pointing of Unreinforced Masonry Walls > 21.804 — Packing
401.2 Plumbing Fixtures and Fixture Fittings, Quality of Fixtures
Plumbing fixtures shall be constructed
of dense, durable, non-absorbent materials and shall
have smooth, impervious surfaces, free from unnecessary ...
California Plumbing Code 2019 > 4 Plumbing Fixtures and Fixture Fittings > 401.0 General > 401.2 Quality of Fixtures