UpCodes logo
Go To Full Code Chapter
3301.6.1 Sizes
All sizes and dimensions prescribed in this chapter are minimum requirements. Lumber sizes are nominal or commercial except where stated otherwise.
3301.6.2 Stresses
Temporary equipment and constructions shall be designed so that the allowable stress values for the material as specified by this code are not exceeded.
3301.6.3 Design Capacity
No structure, device, or equipment, whether permanent or temporary, including all partly or fully completed elements or sections of the building, shall be loaded in excess of its design capacity.

Related Code Sections

Article 10 Precautions During Building Operations [PDF] (page 2)
). §C26-556.0 Sizes and Stresses of Materials Used for Protection of the Public and Workmen.a. The sizes mentioned in this article are minimum requirements ...
Article 8 Materials, Loads and Stresses [PDF] (page 25)
be of sufficient size to carry the dead and required live loads without exceeding the allowable working stresses hereinafter specified. b. Minimum ...
Article 8 Materials, Loads and Stresses [PDF] (page 4)
Working stresses for special steel.-The maximum allowable working stresses for special steels shall be determined in accordance with the physical ...
Article 8 Materials, Loads and Stresses [PDF] (page 30)
8. These grades are applicable to 2 inch thickness only. 9. These grades are applicable only in sizes 3 inches and thicker ...