// CODE SNIPPET

1910.216(c)(2) Safety Trip, Side

OSHA 1910 General Industry > O Machinery and Machine Guarding > 1910.216 Mills and Calenders in the Rubber and Plastics Industries > 1910.216(c) Calender Safety Controls > 1910.216(c)(2) Safety Trip, Side

Go To Full Code Chapter

On both sides of the calender and near each end of the face of the roll, there shall be a cable or wire center cord connected to the safety trip. They shall operate readily when pushed or pulled.

Upcodes Diagrams

Related Code Sections

1910.216(c)(2) Machinery and Machine Guarding, Safety Trip, Side

On both sides of the calender and near each end of the face of the roll, there shall be a cable or wire center cord connected to the safety trip ...

1910.211(d)(55) Machinery and Machine Guarding, Trip or (Tripping)

Trip or (tripping) means activation of the clutch to "run" the press ...

OSHA 1910 General Industry > O Machinery and Machine Guarding > 1910.211 Definitions > 1910.211(d) > 1910.211(d)(55) Trip or (Tripping)

1910.262(bb)(2) Special Industries, Safety Stop Bar

A safety trip rod, cable or wire center cord shall be provided across the front and back of all rope washers extending the length of the face ...

OSHA 1910 General Industry > R Special Industries > 1910.262 Textiles > 1910.262(bb) Rope Washers > 1910.262(bb)(2) Safety Stop Bar

1910.265(d)(1)(i)(a) Special Industries,

at the opposite side of the load being tripped ...

OSHA 1910 General Industry > R Special Industries > 1910.265 Sawmills > 1910.265(d) Log Handling, Sorting, and Storage > 1910.265(d)(1) Log Unloading Methods, Equipment, and Facilities > 1910.265(d)(1)(i) Unloading Methods > 1910.265(d)(1)(i)(a)

1910.217(c)(3)(viii) Machinery and Machine Guarding,

The two hand trip device shall protect the operator as specified in paragraph (c)(3)(i)(e) of this section ...

OSHA 1910 General Industry > O Machinery and Machine Guarding > 1910.217 Mechanical Power Presses > 1910.217(c) Safeguarding the Point of Operation > 1910.217(c)(3) Point of Operation Devices > 1910.217(c)(3)(viii)