// CODE SNIPPET
2.22.5.2 Return Speed
Go To Full Code Chapter
Upon activation (compression) of the buffer, the return speed of the car or counterweight shall not exceed 1 m/s (200 ft/min).
Related Code Sections
2.22.5.2 Electric Elevators, Return Speed
Upon activation (compression) of the buffer, the return speed of the car or counterweight shall not exceed 1 m/s (200 ft/min) ...
6.5.3.2.4 Heating, Ventilating, and Air Conditioning, Return and Relief Fan Control
building pressure either directly, or indirectly through differential supply-return airflow tracking. Systems with constant speed or multispeed supply ...
8.3.2.5.2 General Requirements, Strength Tests
or injury. If no damage is apparent, the buffer shall then be fully compressed at low speed and then released to determine if it will return freely ...
3.26.7 Hydraulic Elevators, Recycling Operation for Multiple or Telescopic Plungers
are closed and locked (c) no car calls are registered (d) the speed during recycling does not exceed normal down leveling speed but in no case shall ...
8.4.10.1.3 General Requirements, Elevator Operation, Seismic Detection Device Actuation (See Figure 8.4.10.1.3)
return to normal operation. The "EARTHQUAKE SLOW SPEED," "EARTHQUAKE MODE," and "SEISMIC STATUS" visual indications shall extinguish.
NOTE: Since ...
Safety Code for Elevators and Escalators 2019 of Illinois > 8 General Requirements > 8.4 Elevator Seismic Requirements > 8.4.10 Emergency Operation and Signaling Devices > 8.4.10.1 Operation of Elevators Under Earthquake Emergency Conditions > 8.4.10.1.3 Elevator Operation, Seismic Detection Device Actuation (See Figure 8.4.10.1.3)