// CODE SNIPPET
1910.106(e)(8) Repairs to Equipment
JUMP TO FULL CODE CHAPTER
Hot work, such as welding or cutting operations, use of spark-producing power tools, and chipping operations shall be permitted only under supervision of an individual in responsible charge. The individual in responsible charge shall make an inspection of the area to be sure that it is safe for the work to be done and that safe procedures will be followed for the work specified.
Related Code Sections
1910.106(e)(8) Hazardous Materials, Repairs to Equipment
Hot work, such as welding or cutting operations, use of spark-producing power tools, and chipping operations shall be permitted only under supervision ...
OSHA 1910 General Industry > H Hazardous Materials > 1910.106 Flammable Liquids > 1910.106(e) Industrial Plants > 1910.106(e)(8) Repairs to Equipment
1910.137(c)(2)(xi) Personal Protective Equipment,
Repaired insulating equipment shall be retested before it may be used by employees ...
OSHA 1910 General Industry > I Personal Protective Equipment > 1910.137 Electrical Protective Equipment > 1910.137(c) In-Service Care and Use of Electrical Protective Equipment > 1910.137(c)(2) Specific Requirements > 1910.137(c)(2)(xi)
1910.269(l)(2)(i)(C) Special Industries,
Installation, removal, or repair of equipment, such as transformers, capacitors, and regulators, if an employee is exposed to contact with parts ...
OSHA 1910 General Industry > R Special Industries > 1910.269 Electric Power Generation, Transmission, and Distribution > 1910.269(l) Working on or Near Exposed Energized Parts > 1910.269(l)(2) At Least Two Employees > 1910.269(l)(2)(i) > 1910.269(l)(2)(i)(C)
1910.304(b)(3)(ii)(C)(4)(iii) Electrical,
All required tests shall be performed before first use; before equipment is returned to service following any repairs; before equipment is used after ...
OSHA 1910 General Industry > S Electrical > 1910.304 Wiring Design and Protection > 1910.304(b) Branch Circuits > 1910.304(b)(3) Ground-Fault Circuit Interrupter Protection for Personnel > 1910.304(b)(3)(ii) > 1910.304(b)(3)(ii)(C) > 1910.304(b)(3)(ii)(C)(4) > 1910.304(b)(3)(ii)(C)(4)(iii)
1910.268(b)(1)(i) Special Industries, Illumination
and repair of equipment frame lineups, may require a higher level of illumination. In such cases, the employer shall install permanent lighting ...
OSHA 1910 General Industry > R Special Industries > 1910.268 Telecommunications > 1910.268(b) General > 1910.268(b)(1) Buildings Containing Telecommunications Centers > 1910.268(b)(1)(i) Illumination