// CODE SNIPPET
1910.252(b)(2)(iii) Protection From Arc Welding Rays
JUMP TO FULL CODE CHAPTER
Where the work permits, the welder should be enclosed in an individual booth painted with a finish of low reflectivity such as zinc oxide (an important factor for absorbing ultraviolet radiations) and lamp black, or shall be enclosed with noncombustible screens similarly painted. Booths and screens shall permit circulation of air at floor level. Workers or other persons adjacent to the welding areas shall be protected from the rays by noncombustible or flameproof screens or shields or shall be required to wear appropriate goggles.
Related Code Sections
1910.252(b)(2)(iii) Welding, Cutting, and Brazing, Protection From Arc Welding Rays
shall permit circulation of air at floor level. Workers or other persons adjacent to the welding areas shall be protected from the rays ...
OSHA 1910 General Industry > Q Welding, Cutting, and Brazing > 1910.252 General Requirements > 1910.252(b) Protection of Personnel > 1910.252(b)(2) Eye Protection > 1910.252(b)(2)(iii) Protection From Arc Welding Rays
1910.254(b) Welding, Cutting, and Brazing, Application of Arc Welding Equipment
for operation in atmospheres containing gases, dust, and light rays produced by the welding arc ...
OSHA 1910 General Industry > Q Welding, Cutting, and Brazing > 1910.254 Arc Welding and Cutting > 1910.254(b) Application of Arc Welding Equipment
1910.252(d)(1) Welding, Cutting, and Brazing, Transmission Pipeline
When arc welding is performed in wet conditions, or under conditions of high humidity, special ...
OSHA 1910 General Industry > Q Welding, Cutting, and Brazing > 1910.252 General Requirements > 1910.252(d) Industrial Applications > 1910.252(d)(1) Transmission Pipeline
1910.254(b)(4) Welding, Cutting, and Brazing, Design
Terminals for welding leads should be protected from ...
OSHA 1910 General Industry > Q Welding, Cutting, and Brazing > 1910.254 Arc Welding and Cutting > 1910.254(b) Application of Arc Welding Equipment > 1910.254(b)(4) Design
1910.254(b)(4)(iv) Welding, Cutting, and Brazing,
Terminals for welding leads should be protected from accidental electrical contact by personnel or by metal objects i.e., vehicles, crane hooks, etc ...
OSHA 1910 General Industry > Q Welding, Cutting, and Brazing > 1910.254 Arc Welding and Cutting > 1910.254(b) Application of Arc Welding Equipment > 1910.254(b)(4) Design > 1910.254(b)(4)(iv)