UpCodes logo
Go To Full Code Chapter
The temperature of the parts heated prior to coating shall not exceed the ignition temperature of the powder to be used.

Related Code Sections

Article 9 Construction [PDF] (page 37)
be unlawful to use such lintels for spans exceeding six feet. (8.6.1.3). §C26-512.0 Cast Iron Column Bases.-All parts of a cast iron base or bearing plate ...
Reference Standard 16 Plumbing and Gas Piping [PDF] (page 36)
tanks operated by ballcocks shall have a vacuum breaker located not less than 1 in. above the overflow outlet of the flush tank. P107.21 Preheating ...
§27-797 Heating and Combustion Equipment, Certificates
of subchapter one of this chapter. (a) Every oil burning installation that is not fully automatic or requires preheating shall be operated ...
1.1.3 General, Application of Parts
This Code applies to new installations only, except Part 1, and 5.10, 8.1, 8.6, 8.7, 8.8, 8.9, 8.10, and 8.11, that apply to both new and existing ...
1002.9 Dwelling Units and Sleeping Units, Operable Parts
Lighting controls, electrical panelboards, electrical switches and receptacle outlets, environmental controls, appliance controls, operating hardware ...