// CODE SNIPPET
R703.14.1 Polypropylene Siding and Accessories
JUMP TO FULL CODE CHAPTER
Unless otherwise specified in the approved manufacturer's instructions, nails shall be corrosion resistant, with a minimum 0.120-inch (3 mm) shank and minimum 0.313-inch (8 mm) head diameter. Nails shall be a minimum of 11/4 inches (32 mm) long or as necessary to penetrate sheathing or substrate not less than 3/4 inch (19.1 mm). Where the nail fully penetrates the sheathing or nailable substrate, the end of the fastener shall extend not less than 1/4 inch (6.4 mm) beyond the opposite face of the sheathing or substrate. Staples are not permitted.
Related Code Sections
R703.14.1 Wall Covering, Polypropylene Siding and Accessories
Polypropylene siding and accessories shall be installed in accordance with manufacturer's installation instructions ...
Residential Code 2018 of Kansas > 7 Wall Covering > R703 Exterior Covering > R703.14 Polypropylene Siding > R703.14.1 Polypropylene Siding and Accessories
1403.12 Exterior Walls, Polypropylene Siding
Polypropylene siding shall be certified and labeled as conforming to the requirements of ASTM D7254 and those of Section 1403.12.1 or 1403.12.2 ...
1404.18 Exterior Walls, Polypropylene Siding
Polypropylene siding conforming to the requirements of this section and complying with Section 1403.12 shall be limited to exterior walls located ...
Building Code 2018 of Kansas > 14 Exterior Walls > 1404 Installation of Wall Coverings > 1404.18 Polypropylene Siding
705.15 Sanitary Drainage, Polypropylene Plastic
The joint between polypropylene plastic pipe and fittings shall incorporate an elastomeric seal. The joint shall conform to ASTM D3212. Mechanical ...
1403.12.2 Exterior Walls, Fire Separation Distance
The fire separation distance between a building with polypropylene siding and the adjacent building shall be not less than 10 feet (3048 mm) ...
Building Code 2018 of Kansas > 14 Exterior Walls > 1403 Materials > 1403.12 Polypropylene Siding > 1403.12.2 Fire Separation Distance