// CODE SNIPPET
Section 21.1307 — Plasticity
JUMP TO FULL CODE CHAPTER
The putty made from Type S, special hydrate, or Type SA, special air-entraining hydrate, shall have a plasticity figure of not less than 200 within 30 minutes after mixing with water, when tested.
Related Code Sections
1221.2.3 Hydronics, Plastics
Plastic pipe and tubing shall be
installed in continuous lengths or shall be joined by heat
fusion method ...
Los Angeles Mechanical Code > 12 Hydronics > 1221.0 Piping Installation > 1221.2 Embedded Piping and Joints > 1221.2.3 Plastics
1221.2.3 Hydronics, Plastics
Plastic pipe and tubing shall be
installed in continuous lengths or shall be joined by heat
fusion method ...
Los Angeles Mechanical Code > 12 Hydronics > 1221.0 Piping Installation > 1221.2 Embedded Piping Materials and Joints > 1221.2.3 Plastics
1403.8 Exterior Walls, Plastics
Plastic panel, apron or spandrel walls as defined in this code shall not be limited in thickness, provided that such plastics and their assemblies ...
1404.8 Exterior Walls, Plastics
Plastic panel, apron or spandrel walls as defined in this code shall not be limited in thickness, provided that such plastics and their assemblies ...
Section 21.1307 Referenced Standards, — Plasticity
The putty made from Type S, special hydrate, or Type SA, special air-entraining hydrate, shall have a plasticity figure of not less than 200 within ...
Los Angeles Existing Building Code > Referenced Standards > 21-13 Hydrated Lime for Masonry Purposes > 21.1307 — Plasticity