// CODE SNIPPET
Appendix A Permit-Required Confined Space Decision Flow Chart
JUMP TO FULL CODE CHAPTER
1 Spaces may have to be evacuated and re-evacuated if hazards arise during entry
[58 FR 4549, Jan. 14, 1993; 58 FR 34846, June 29, 1993; 63 FR 66039, Dec. 1, 1998]
*Accessibility Assistance: Contact OSHA's Directorate of Standards and Guidance at (202) 693-1950 for assistance accessing PDF or image documents.
Appendix A to §1910.146 -- Permit-Required Confined Space Decision Flow Chart
Note: Appendices A through F serve to provide information and non-mandatory guidelines to assist employers and employees in complying with the appropriate requirements of this section.
[58 FR 4549, Jan. 14, 1993; 58 FR 34846, June 29, 1993; 63 FR 66039, Dec. 1, 1998]
*Accessibility Assistance: Contact OSHA's Directorate of Standards and Guidance at (202) 693-1950 for assistance accessing PDF or image documents.
Related Code Sections
Appendix A General Environmental Controls, Permit-Required Confined Space Decision Flow Chart
Appendix A to §1910.146 -- Permit-Required Confined Space Decision Flow Chart
Note : Appendices A through F serve to provide information ...
OSHA 1910 General Industry > J General Environmental Controls > 1910.146 Permit-Required Confined Spaces > A Permit-Required Confined Space Decision Flow Chart
Appendix A Special Industries, Flow Charts
(Permit-required confined spaces), and between § 1910.269 and § 1910.147 (The control of hazardous energy (lockout/tagout)). These flow charts provide ...
OSHA 1910 General Industry > R Special Industries > 1910.269 Electric Power Generation, Transmission, and Distribution > A Flow Charts
1910.252(a)(4) Welding, Cutting, and Brazing, Confined Spaces
Where practicable, the torch and hose shall also be removed from the confined space ...
OSHA 1910 General Industry > Q Welding, Cutting, and Brazing > 1910.252 General Requirements > 1910.252(a) Fire Prevention and Protection > 1910.252(a)(4) Confined Spaces
1910.252(c)(9)(ii) Welding, Cutting, and Brazing, Confined Space
if the work is to be done in a confined space ...
OSHA 1910 General Industry > Q Welding, Cutting, and Brazing > 1910.252 General Requirements > 1910.252(c) Health Protection and Ventilation > 1910.252(c)(9) Cadmium > 1910.252(c)(9)(ii) Confined Space
Appendix E General Environmental Controls, Sewer System Entry
Sewer entry differs in three vital respects from other permit entries; first, there rarely exists any way to completely isolate the space (a section ...
OSHA 1910 General Industry > J General Environmental Controls > 1910.146 Permit-Required Confined Spaces > E Sewer System Entry