// CODE SNIPPET
1910.219(f)(4) Openings for Oiling
JUMP TO FULL CODE CHAPTER
When frequent oiling must be done, openings with hinged or sliding self-closing covers shall be provided. All points not readily accessible shall have oil feed tubes if lubricant is to be added while machinery is in motion.
Related Code Sections
1910.219(f)(4) Machinery and Machine Guarding, Openings for Oiling
When frequent oiling must be done, openings with hinged or sliding self-closing covers shall be provided. All points not readily accessible shall ...
OSHA 1910 General Industry > O Machinery and Machine Guarding > 1910.219 Mechanical Power-Transmission Apparatus > 1910.219(f) Gears, Sprockets, and Chains > 1910.219(f)(4) Openings for Oiling
1910.262(t) Special Industries, Tenter Frames
end of the frame at the in-running chain and clip opener ...
1910.305(j)(5)(v) Electrical,
Combustible material, combustible buildings and parts of buildings, fire escapes, and door and window openings shall be safeguarded from fires ...
OSHA 1910 General Industry > S Electrical > 1910.305 Wiring Methods, Components, and Equipment for General Use > 1910.305(j) Equipment for General Use > 1910.305(j)(5) Transformers > 1910.305(j)(5)(v)
1910.265(e)(5)(ii)(a) Special Industries,
The top and the openings in end and side frames of edgers shall be adequately guarded and gears and chains shall be fully housed. Guards may ...
OSHA 1910 General Industry > R Special Industries > 1910.265 Sawmills > 1910.265(e) Log Breakdown and Related Machinery and Facilities > 1910.265(e)(5) Edgers > 1910.265(e)(5)(ii) Guards > 1910.265(e)(5)(ii)(a)
1910.169(b)(2) Compressed Gas and Compressed Air Equipment, Drains and Traps
A drain pipe and valve shall be installed at the lowest point of every air receiver to provide for the removal of accumulated oil and water. Adequate ...
OSHA 1910 General Industry > M Compressed Gas and Compressed Air Equipment > 1910.169 Air Receivers > 1910.169(b) Installation and Equipment Requirements > 1910.169(b)(2) Drains and Traps