// CODE SNIPPET
1926.967(c)(2) Opening a Series Loop
JUMP TO FULL CODE CHAPTER
Before any employee opens a series loop, the employer shall deenergize the streetlighting transformer and isolate it from the source of supply or shall bridge the loop to avoid an open-circuit condition.
Related Code Sections
1926.967(c)(2) Electric Power Transmission and Distribution, Opening a Series Loop
Before any employee opens a series loop, the employer shall deenergize the streetlighting transformer and isolate it from the source of supply ...
OSHA 1926 Construction > V Electric Power Transmission and Distribution > 1926.967 Special Conditions > 1926.967(c) Series Streetlighting > 1926.967(c)(2) Opening a Series Loop
1926.757(b) Steel Erection, Attachment of Steel Joists and Steel Joist Girders
Each end of "K" series steel joists shall be attached to the support structure with a minimum of two 1 / 8 -inch (3 mm) fillet welds 1 inch (25 mm ...
OSHA 1926 Construction > R Steel Erection > 1926.757 Open Web Steel Joists > 1926.757(b) Attachment of Steel Joists and Steel Joist Girders
1926.909 Blasting and the Use of Explosives, Firing the Blast
WARNING SIGNAL
-
A 1-minute series of long blasts 5 minutes prior to, blast signal.
BLAST SIGNAL
-
A series ...
1926.954(b)(2)(ix) Electric Power Transmission and Distribution,
Tool loops shall be situated on the body of a body belt so that the 100 millimeters (4 inches) of the body belt that is in the center of the back ...
OSHA 1926 Construction > V Electric Power Transmission and Distribution > 1926.954 Personal Protective Equipment > 1926.954(b) Fall Protection > 1926.954(b)(2) Work-Positioning Equipment > 1926.954(b)(2)(ix)
1926.909(a) Blasting and the Use of Explosives,
WARNING SIGNAL
-
A 1-minute series of long blasts 5 minutes prior to, blast signal.
BLAST SIGNAL
-
A series ...
OSHA 1926 Construction > U Blasting and the Use of Explosives > 1926.909 Firing the Blast > 1926.909(a)