// CODE SNIPPET
P-407.3 O-Ring and Gasket-Type Joints
JUMP TO FULL CODE CHAPTER
O-ring and gasket-type joints in accordance with Section P-305 shall be
permitted outside the building more than 10 feet from the building wall. This type of joint is permitted for joining
cast iron pipe to clay pipe, and cast iron pipe to concrete sewer pipe.
Related Code Sections
P-407.3 Joints, O-Ring and Gasket-Type Joints
O-ring and gasket-type joints in accordance with Section P-305 shall be
permitted outside the building more than 10 feet from the building wall. This ...
Philadelphia Plumbing Code > 4 Joints > P-407 Clay and Concrete Sewer Pipe Joints > P-407.3 O-Ring and Gasket-Type Joints
P-305.5 Materials, Pipes and Joints Permitted
, Compression, Threaded
Terra Cotta
Bell-and-Spigot (slip seal), Gasket and O-Ring
Brass and Copper Pipe
Threaded ...
Philadelphia Plumbing Code > 3 Materials > P-305 Materials for Plumbing Installations > P-305.5 Pipes and Joints Permitted
403.13 Gas Piping Installations, Flange Gaskets
in choosing material. Acceptable materials include metal (plain or corrugated), composition, aluminum "O" rings, spiral wound metal gaskets, rubber-faced ...
Philadelphia Fuel Gas Code > 4 Gas Piping Installations > 403 (IFGS) Piping Materials > 403.13 Flange Gaskets
1203.9.1 Hydronic Piping, Compression-Type Fittings
Where compression-type fittings include inserts and ferrules or O-rings, the fittings shall be installed without omitting the inserts and ferrules ...
Philadelphia Mechanical Code > 12 Hydronic Piping > 1203 Joints and Connections > 1203.9 Cross-Linked Polyethylene (PEX) Plastic Tubing > 1203.9.1 Compression-Type Fittings
1210.6 Hydronic Piping, Joints
Where compression-type fittings include inserts and ferrules or O-rings ...
Philadelphia Mechanical Code > 12 Hydronic Piping > 1210 Plastic Pipe Ground-Source Heat Pump Loop Systems > 1210.6 Joints