// CODE SNIPPET
1910.252(a)(2)(x) Noncombustible Walls
JUMP TO FULL CODE CHAPTER
If welding is to be done on a metal wall, partition, ceiling or roof, precautions shall be taken to prevent ignition of combustibles on the other side, due to conduction or radiation, preferably by relocating combustibles. Where combustibles are not relocated, a fire watch on the opposite side from the work shall be provided.
Related Code Sections
1910.252(a)(2)(x) Welding, Cutting, and Brazing, Noncombustible Walls
If welding is to be done on a metal wall, partition, ceiling or roof, precautions shall be taken to prevent ignition of combustibles on the other ...
OSHA 1910 General Industry > Q Welding, Cutting, and Brazing > 1910.252 General Requirements > 1910.252(a) Fire Prevention and Protection > 1910.252(a)(2) Special Precautions > 1910.252(a)(2)(x) Noncombustible Walls
1910.107(d)(8) Hazardous Materials, Discharge Clearance
combustible exterior wall or roof nor discharge in the direction of any combustible construction or unprotected opening in any noncombustible exterior ...
OSHA 1910 General Industry > H Hazardous Materials > 1910.107 Spray Finishing Using Flammable and Combustible Materials > 1910.107(d) Ventilation > 1910.107(d)(8) Discharge Clearance
1910.103(c)(3)(i) Hazardous Materials, Outdoor Locations
If protective walls are provided, they shall be constructed of noncombustible materials and in accordance ...
OSHA 1910 General Industry > H Hazardous Materials > 1910.103 Hydrogen > 1910.103(c) Liquefied Hydrogen Systems > 1910.103(c)(3) Design Considerations at Specific Locations > 1910.103(c)(3)(i) Outdoor Locations
1910.253(f)(6)(i)(E) Welding, Cutting, and Brazing,
of the following:
Walls of light, noncombustible material preferably single-thickness, single-strength glass; lightly fastened hatch covers; lightly fastened ...
OSHA 1910 General Industry > Q Welding, Cutting, and Brazing > 1910.253 Oxygen-Fuel Gas Welding and Cutting > 1910.253(f) Acetylene Generators > 1910.253(f)(6) > 1910.253(f)(6)(i) > 1910.253(f)(6)(i)(E)
1910.253(f)(6)(i) Welding, Cutting, and Brazing,
Walls, floors, and roofs of outside generator houses shall be of noncombustible ...
OSHA 1910 General Industry > Q Welding, Cutting, and Brazing > 1910.253 Oxygen-Fuel Gas Welding and Cutting > 1910.253(f) Acetylene Generators > 1910.253(f)(6) > 1910.253(f)(6)(i)