UpCodes logo
Go To Full Code Chapter
Motor-feeder and branch-circuit conductors shall be permitted to be protected against overcurrent in accordance with 430.28 and 430.53, respectively.

Related Code Sections

(F) Wiring and Protection, Motor Circuit Taps
Motor-feeder and branch-circuit conductors shall be permitted to be protected against overcurrent in accordance with 430.28 and 430.53, respectively ...
(F) Wiring and Protection, Motor Circuit Taps
Motor-feeder and branch-circuit conductors shall be permitted to be protected against overcurrent in accordance with 430.28 and 430.53, respectively ...
(A) Equipment for General Use, General
A motor control circuit tapped from the load side of a motor branch-circuit short-circuit and ground-fault protective device(s) and functioning ...
(A) Equipment for General Use, General
A motor control circuit tapped from the load side of a motor branch-circuit short-circuit and ground-fault protective device(s) and functioning ...
(B) Special Equipment, Taps
Where two or more motors are connected to the same branch circuit, each tap conductor to an individual motor shall have an ampacity not less than one ...