// CODE SNIPPET
1910.305(h)(5) Minimum Bending Radii
JUMP TO FULL CODE CHAPTER
The minimum bending radii for portable cables during installation and handling in service shall be adequate to prevent damage to the cable.
Related Code Sections
1910.305(h)(5) Electrical, Minimum Bending Radii
The minimum bending radii for portable cables during installation and handling in service shall be adequate to prevent damage to the cable ...
OSHA 1910 General Industry > S Electrical > 1910.305 Wiring Methods, Components, and Equipment for General Use > 1910.305(h) Portable Cables Over 600 Volts, Nominal > 1910.305(h)(5) Minimum Bending Radii
1910.181(c)(1)(i) Materials Handling and Storage,
Manufacturer's approved load ratings at corresponding ranges of boom angle or operating radii ...
OSHA 1910 General Industry > N Materials Handling and Storage > 1910.181 Derricks > 1910.181(c) Load Ratings > 1910.181(c)(1) Rated Load Marking > 1910.181(c)(1)(i)
1910.180(a)(3) Materials Handling and Storage, Truck Crane
with a powerplant for travel. Its function is to hoist and swing loads at various radii ...
OSHA 1910 General Industry > N Materials Handling and Storage > 1910.180 Crawler Locomotive and Truck Cranes > 1910.180(a) Definitions Applicable to This Section > 1910.180(a)(3) Truck Crane
1910.180(a)(4) Materials Handling and Storage, Wheel Mounted Crane
with a separate engine controlled from the superstructure. Its function is to hoist and swing loads at various radii ...
OSHA 1910 General Industry > N Materials Handling and Storage > 1910.180 Crawler Locomotive and Truck Cranes > 1910.180(a) Definitions Applicable to This Section > 1910.180(a)(4) Wheel Mounted Crane
1910.180(c)(1)(i) Materials Handling and Storage,
The margin of stability for determination of load ratings, with booms of stipulated lengths at stipulated working radii for the various types ...
OSHA 1910 General Industry > N Materials Handling and Storage > 1910.180 Crawler Locomotive and Truck Cranes > 1910.180(c) Load Ratings > 1910.180(c)(1) Load Ratings > 1910.180(c)(1)(i)