// CODE SNIPPET
Related Code Sections
(2) Wiring and Protection, Methods
Bonding shall be in compliance with 250.92(B) and ensured by one of the methods in 250.92(B)(2) through (B)(4) ...
National Electrical Code 2020 of Minnesota > 2 Wiring and Protection > 250 Grounding and Bonding > 250.64 Grounding Electrode Conductor Installation > (E) Raceways and Enclosures for Grounding Electrode Conductors > (2) Methods
907.8.4 Fire Protection Systems, Method
To verify that each smoke detector is within its listed and marked sensitivity range, it shall be tested using one of the following methods: A ...
Minnesota Fire Code 2015 > 9 Fire Protection Systems > 907 Fire Alarm and Detection Systems > 907.8 Inspection, Testing and Maintenance > 907.8.4 Method
110.8 General, Wiring Methods
Only wiring methods recognized as suitable are included in this Code. The recognized methods of wiring shall be permitted to be installed in any ...
National Electrical Code 2020 of Minnesota > 1 General > 110 Requirements for Electrical Installations > 110.8 Wiring Methods
14.4.3* Inspection, Testing, and Maintenance, Test Methods
equipment shall be tested according to Table 188.8.131.52. Table 184.108.40.206 Testing Component Initial Acceptance Periodic Frequency Method ...
National Fire Alarm and Signaling Code 2016 of Minnesota > 14 Inspection, Testing, and Maintenance > 14.4 Testing > 14.4.3* Test Methods
1605.1 Installation and Testing of Oil or Liquid Fuel-Fired Equipment, Method of Test
Method of test — atmospheric type/induced draft type/fan assisted types. The appliance shall be allowed to operate until the stack temperature ...
Minnesota Mechanical Code 2015 > 16 Installation and Testing of Oil or Liquid Fuel-Fired Equipment > 1605 > 1605.1 Method of Test