// CODE SNIPPET
[BS] C104.3.2 Method #1: Face-to-Edge or Face-to-Face Method
Go To Full Code Chapter
Retrofit studs shall be installed immediately adjacent to existing gable end wall studs as indicated in Figure C104.3(a). The retrofit studs shall overlap the edge or side of the existing stud by not less than 11/4 inches (32 mm). Fasteners shall be installed as specified in Section C104.3.1.
Related Code Sections
C104.3.2 Guidelines for the Wind Retrofit of Existing Buildings, Method #1: Face-to-Edge or Face-to-Face Method
overlap the edge or side of the existing stud by not less than 11/4 inches (32 mm). Fasteners shall be installed as specified in Section C104.3.1 ...
8.11.6 Two-Way Slabs, Factored Moments
supports with brackets or capitals, the critical section for negative Mu in the span perpendicular to an edge shall be taken at a distance from the face ...
1208.6.13.6 Fuel Gas Piping, Flange Facings
Standard facings shall be permitted for use under this code. Where 150 psi (1034 kPa) steel flanges are bolted to Class 125 cast-iron flanges ...
1308.5.10.5 Fuel Gas Piping, Flange Facings
Standard facings shall be permitted for use under this code. Where 150 psi (1034 kPa) steel flanges are bolted to Class 125 cast-iron flanges ...
720.2.1 Fire and Smoke Protection Features, Facings
limitations do not apply to facings, coverings, and layers of reflective foil insulation that are installed behind and in substantial contact ...