// CODE SNIPPET
510.7.4 Mechanical and Structural Integrity
JUMP TO FULL CODE CHAPTER
Field-applied grease duct enclosures and factory-built grease duct enclosures shall provide mechanical and structural integrity, resiliency, and stability where subjected to expected building environmental conditions, duct movement under general operating conditions, and duct movement as a result of interior and exterior fire conditions. [NFPA 96:7.7.2.2.5]
Related Code Sections
510.7.4 Exhaust Systems, Mechanical and Structural Integrity
Field-applied grease duct enclosures and factory-built grease duct enclosures shall provide mechanical and structural integrity, resiliency ...
2018 Uniform Mechanical Code of Nevada > 5 Exhaust Systems > 510.0 Exhaust Duct Systems > 510.7 Interior Installations > 510.7.4 Mechanical and Structural Integrity
507.4.6 Exhaust Systems, Both Field-Applied and Factory Built
Field-applied grease duct enclosures and factory-built grease duct enclosures shall demonstrate that they provide mechanical and structural integrity ...
2018 Uniform Mechanical Code of Nevada > 5 Exhaust Systems > 507.0 General Requirements > 507.4 Clearance > 507.4.6 Both Field-Applied and Factory Built
8.7.4.2 Two-Way Slabs, Structural Integrity
All bottom deformed bars or deformed wires within the column strip, in each direction, shall be continuous or spliced with full mechanical, full ...
Building Code Requirements for Structural Concrete of Nevada > 8 Two-Way Slabs > 8.7 Reinforcement Detailing > 8.7.4 Flexural Reinforcement in Nonprestressed Slabs > 8.7.4.2 Structural Integrity
9.7.7 Beams, Structural Integrity Reinforcement in Cast-In-Place Beams
For beams along the perimeter of the structure, structural integrity reinforcement shall be in accordance with (a) through (c): (a) At least one ...
Building Code Requirements for Structural Concrete of Nevada > 9 Beams > 9.7 Reinforcement Detailing > 9.7.7 Structural Integrity Reinforcement in Cast-In-Place Beams
Section 1615 Structural Design, Structural Integrity
High-rise buildings that are assigned to Risk Category III or IV shall comply with the requirements of this section. Frame structures shall comply ...