Section C303 Materials, Systems and Equipment
An R-value identification mark shall be applied by the manufacturer to each piece of building thermal envelope insulation 12 inches (305 mm) or greater in width. Alternatively, the insulation installers shall provide a certification listing the type, manufacturer and R-value of insulation installed in each element of the building thermal envelope. For blown-in or sprayed fiberglass and cellulose insulation, the initial installed thickness, settled thickness, settled R-value, installed density, coverage area and number of bags installed shall be listed on the certification. For sprayed polyurethane foam (SPF) insulation, the installed thickness of the areas covered and R-value of installed thickness shall be listed on the certification. For insulated siding, the R-value shall be labeled on the product's package and shall be listed on the certification. The insulation installer shall sign, date and post the certification in a conspicuous location on the job site.
U-factors of fenestration products shall be determined as follows:
- For windows, doors and skylights, U-factor ratings shall be determined in accordance with NFRC 100.
- Where required for garage doors and rolling doors, U-factor ratings shall be determined in accordance with either NFRC 100 or ANSI/DASMA 105.
U-factors shall be determined by an accredited, independent laboratory, and labeled and certified by the manufacturer.
Products lacking such a labeled U-factor shall be assigned a default U-factor from Table C303.1.3(1) or C303.1.3(2). The solar heat gain coefficient (SHGC) and visible transmittance (VT) of glazed fenestration products (windows, glazed doors and skylights) shall be determined in accordance with NFRC 200 by an accredited, independent laboratory, and labeled and certified by the manufacturer. Products lacking such a labeled SHGC or VT shall be assigned a default SHGC or VT from Table C303.1.3(3).
DEFAULT GLAZED WINDOW, GLASS DOOR AND SKYLIGHT U-FACTORS
|FRAME TYPE||WINDOW AND|
|Metal with Thermal Break||1.10||0.65||1.90||1.10|
|Nonmetal or Metal Clad||0.95||0.55||1.75||1.05|
DEFAULT OPAQUE DOOR U-FACTORS
|Insulated Metal (Rolling)||0.90|
|Insulated Metal (Other)||0.60|
|Insulated, nonmetal edge, max 45% glazing, |
any glazing double pane