// CODE SNIPPET
3113.3 Manufacturer's Data Plate
JUMP TO FULL CODE CHAPTER
Each relocatable module shall have a data plate that is permanently attached on or adjacent to the electrical panel, and shall include the following information:
- Occupancy group.
- Manufacturer's name and address.
- Date of manufacture.
- Serial number of module.
- Design roof live load, design floor live load, snow load, wind and seismic design.
- Approved quality assurance agency or approved inspection agency.
- Codes and standards of construction.
- Envelope thermal resistance values.
- Electrical service size.
- Fuel-burning equipment and size.
- Special limitations if any.
Related Code Sections
3113.3 Special Construction, Manufacturer's Data Plate
Each relocatable module shall have a data plate that is permanently attached on or adjacent to the electrical panel, and shall include the following ...
Building Code 2018 of Illinois > 31 Special Construction > 3113 Relocatable Buildings > 3113.3 Manufacturer's Data Plate
11.4.2 Energy Cost Budget Method, Climatic Data
The simulation program shall perform the simulation using hourly values of climatic data, such as temperature and humidity from representative ...
Energy Standard for Buildings Except Low-Rise Residential Buildings 2016 of Illinois > 11 Energy Cost Budget Method > 11.4 Simulation General Requirements > 11.4.2 Climatic Data
C3.2 Normative Appendix C Methodology for Building Envelope Trade-Off Option in Section 5.6, Climatic Data
The simulation program shall perform the simulation using hourly values of climatic data, including temperature, humidity, solar radiation ...
Energy Standard for Buildings Except Low-Rise Residential Buildings 2016 of Illinois > Normative Appendix C Methodology for Building Envelope Trade-Off Option in Section 5.6 > C3 Simulation General Requirements > C3.2 Climatic Data
G2.3 Normative Appendix G Performance Rating Method, Climatic Data
The simulation program shall perform the simulation using hourly values of climatic data, such as temperature and humidity from representative ...
Energy Standard for Buildings Except Low-Rise Residential Buildings 2016 of Illinois > Normative Appendix G Performance Rating Method > G2 Simulation General Requirements > G2.3 Climatic Data
2304.3.1 Wood, Bottom Plates
Studs shall have full bearing on a 2-inch-thick (actual 1 1 / 2 -inch, 38 mm) or larger plate or sill having a width not less than equal to the width ...
Building Code 2018 of Illinois > 23 Wood > 2304 General Construction Requirements > 2304.3 Wall Framing > 2304.3.1 Bottom Plates