// CODE SNIPPET
D.1.4 Manufacturer Instructions
JUMP TO FULL CODE CHAPTER
Where available, the
manufacturer's installation and operating instructions for the
installed appliances should be used as part of these inspection
procedures to determine if it is installed correctly and is operating
properly.
Related Code Sections
D.1.4 Recommended Procedure for Safety Inspection of an Existing Appliance Installation, Manufacturer Instructions
Where available, the
manufacturer's installation and operating instructions for the
installed appliances should be used as part of these inspection ...
2015 Michigan Residential Code > D Recommended Procedure for Safety Inspection of an Existing Appliance Installation > D.1 General > D.1.4 Manufacturer Instructions
307.3 General Regulations, Condensate Pumps
such that
when the pump fails, the appliance or equipment will be prevented
from operating. Pumps shall be installed in accordance
with the manufacturers ...
2015 Michigan Mechanical Code > 3 General Regulations > 307 Condensate Disposal > 307.3 Condensate Pumps
G2427.10.6 Fuel Gas, (503.10.6) Joints
in
accordance with the manufacturers' instructions.
Other approved means.
...
2015 Michigan Residential Code > 24 Fuel Gas > G2427 (503) Venting of Appliances > G2427.10 (503.10) Vent Connectors for Category I Appliances > G2427.10.6 (503.10.6) Joints
R507.8.1 Floors, Deck Post to Deck Footing
at the bottom support. Such lateral restraint
shall be provided by manufactured connectors installed in
accordance with Section R507 and the manufacturers ...
2015 Michigan Residential Code > 5 Floors > R507 Exterior Decks > R507.8 Deck Posts > R507.8.1 Deck Post to Deck Footing
G2425.15.4 Fuel Gas, (501.15.4) Clearances
be not less
than that permitted by the terms of the chimney liner
listing and the manufacturer' s instructions ...
2015 Michigan Residential Code > 24 Fuel Gas > G2425 (501) General > G2425.15 (501.15) Existing Chimneys and Vents > G2425.15.4 (501.15.4) Clearances