// CODE SNIPPET
1926.702(j) Lockout/Tagout Procedures
JUMP TO FULL CODE CHAPTER
No employee shall be permitted to perform maintenance or repair activity on equipment (such as compressors mixers, screens or pumps used for concrete and masonry construction activities) where the inadvertent operation of the equipment could occur and cause injury, unless all potentially hazardous energy sources have been locked out and tagged.
Tags shall read Do Not Start or similar language to indicate that the equipment is not to be operated.
Related Code Sections
1926.702(j) Concrete and Masonry Construction, Lockout/Tagout Procedures
No employee shall be permitted to perform maintenance or repair activity on equipment (such as compressors mixers, screens or pumps used for concrete ...
OSHA 1926 Construction > Q Concrete and Masonry Construction > 1926.702 Requirements for Equipment and Tools > 1926.702(j) Lockout/Tagout Procedures
1926.64(f) Occupational Health and Environmental Controls, Operating Procedures
such as lockout/tagout; confined space entry; opening process equipment or piping; and control over entrance into a facility by maintenance ...
OSHA 1926 Construction > D Occupational Health and Environmental Controls > 1926.64 Process Safety Management of Highly Hazardous Chemicals > 1926.64(f) Operating Procedures
1926.1202 Confined Spaces in Construction, Definitions
of lines, pipes, or ducts; a double block and bleed system; lockout or tagout of all sources of energy; blocking or disconnecting all mechanical linkages ...
1926.417 Electrical, Lockout and Tagging of Circuits
Controls that are to be deactivated during the course of work on energized or deenergized equipment or circuits shall be tagged ...
1926.1206(i) Confined Spaces in Construction,
measures can include, but are not limited to, the lockout or tagging of equipment and procedures for purging, inerting, ventilating, and flushing permit ...