// CODE SNIPPET
917.3.1 Location of Branch
Related Code Sections
917.3.1 Vents, Location of Branch
The horizontal branch drain shall connect to the drainage stack or building drain a maximum of four branch intervals from the top ...
Plumbing Code 2009 of Alabama > 9 Vents > 917 Air Admittance Valves > 917.3 Where Permitted > 917.3.1 Location of Branch
424.95 Equipment for General Use, Location of Branch-Circuit and Feeder Wiring in Walls
). Any wiring behind heating panels or heating panel sets located in interior walls or partitions shall be considered as operating ...
National Electrical Code 2014 of Alabama > 4 Equipment for General Use > 424 Fixed Electric Space-Heating Equipment > 424.95 Location of Branch-Circuit and Feeder Wiring in Walls
(A) Special Occupancies, Patient Bed Location Branch Circuits
Each patient bed location shall be supplied by at least two branch circuits, one or more from the critical branch and one or more circuits from ...
National Electrical Code 2014 of Alabama > 5 Special Occupancies > 517 Health Care Facilities > 517.19 Critical Care Areas > (A) Patient Bed Location Branch Circuits
9.2.3 Hanging, Bracing, and Restraint of System Piping, Location of Hangers on Branch Lines
single section of pipe shall not require a hanger when the cumulative distance between hangers on the branch line does not exceed the spacing required ...
Standard for the Installation of Sprinkler Systems 2013 of Alabama > 9 Hanging, Bracing, and Restraint of System Piping > 9.2* Installation of Pipe Hangers > 9.2.3 Location of Hangers on Branch Lines
The location of the branch circuit disconnecting means shall be permanently identified at the control unit ...
National Fire Alarm and Signaling Code 2013 of Alabama > 10 Fundamentals > 10.6 Power Supplies > 10.6.5 Primary Power Supply > 10.6.5.2 Circuit Identification and Accessibility > 10.6.5.2.1