// CODE SNIPPET
1906.8.4 Location in Slabs, Beams and Girders
JUMP TO FULL CODE CHAPTER
Construction joints in floors shall be located within the middle third of spans of slabs, beams and girders. Joints in girders shall be offset a minimum distance of two times the width of intersecting beams.
Related Code Sections
1906.8.4 Concrete, Location in Slabs, Beams and Girders
Construction joints in floors shall be located within the middle third of spans of slabs, beams and girders. Joints in girders shall be offset ...
NYC Building Code 2008 > 19 Concrete > 1906 Formwork, Embedded Pipes and Construction Joints > 1906.8 Construction Joints > 1906.8.4 Location in Slabs, Beams and Girders
Article 19 Reinforced Concrete and Plain Concrete Construction [PDF] (page 18)
in the bottom layer. §C26-1494.0. Splices in reinforcement of slabs, beams and girders.a. In slabs, beams and girders, splices of reinforcement at points ...
1704.11.4.3.1 Structural Tests and Special Inspections, Beams and Girders
At beams and girders thickness measurements shall be made at nine locations around the beam or girder at each end of a 12-inch (305 mm) length ...
NYC Building Code 2014 > 17 Structural Tests and Special Inspections > 1704 Special Inspections > 1704.11 Sprayed Fire-Resistant Materials > 1704.11.4 Thickness > 1704.11.4.3 Structural Framing Members > 1704.11.4.3.1 Beams and Girders
3305.3.6.4 Safeguards During Construction or Demolition, Reshoring Beam and Girder Construction
Where reshoring of beam and girder construction is required, the forms shall not be removed from more than one girder at a time, and the girder shall ...
NYC Building Code 2014 > 33 Safeguards During Construction or Demolition > 3305 Material Placement and Installation > 3305.3 Concrete Formwork > 3305.3.6 Reshoring > 3305.3.6.4 Reshoring Beam and Girder Construction
2304.10.1.2 Wood, Beams and Girders
Beams and girders shall be at least 6 inches (152 mm) wide and 10 inches (254 mm) deep ...
NYC Building Code 2008 > 23 Wood > 2304 General Construction Requirements > 2304.10 Heavy Timber Construction > 2304.10.1 Minimum Member Sizes > 2304.10.1.2 Beams and Girders