// CODE SNIPPET
[F] 2702.1.4 Load Transfer
JUMP TO FULL CODE CHAPTER
Emergency power systems shall automatically provide secondary power within 10 seconds after primary power is lost, unless specified otherwise in this code. Standby power systems shall automatically provide secondary power within 60 seconds after primary power is lost, unless specified otherwise in this code.
Related Code Sections
2702.1.4 Electrical, Load Transfer
Emergency power systems shall automatically provide secondary power within 10 seconds after primary power is lost, unless specified otherwise ...
Building Code 2018 of Illinois > 27 Electrical > 2702 Emergency and Standby Power Systems > 2702.1 General > 2702.1.4 Load Transfer
16.1 Connections Between Members, Scope
This chapter shall apply to the design of joints and connections at the intersection of concrete members and for load transfer between concrete ...
Building Code Requirements for Structural Concrete of Illinois > 16 Connections Between Members > 16.1 Scope
(1) Special Occupancies, Optional Loads
Loads served by the generating equipment not specifically named in Article 517 shall be served by their own transfer switches such that the following ...
National Electrical Code 2017 of Illinois > 5 Special Occupancies > 517 Health Care Facilities > 517.31 Requirements for the Essential Electrical System > (B) Transfer Switches > (1) Optional Loads
(2) Special Conditions, Automatic Transfer Equipment
Where automatic transfer equipment is used, an optional standby system shall comply with (2)(a) or (2)(b). (a) Full Load. The standby source shall ...
National Electrical Code 2017 of Illinois > 7 Special Conditions > 702 Optional Standby Systems > 702.4 Capacity and Rating > (B) System Capacity > (2) Automatic Transfer Equipment
6.6.2.2 Structural Analysis,
For frames or continuous construction, consideration shall be given to the effect of floor and roof load patterns on transfer of moment to exterior ...
Building Code Requirements for Structural Concrete of Illinois > 6 Structural Analysis > 6.6 First-Order Analysis > 6.6.2 Modeling of Members and Structural Systems > 6.6.2.2