// CODE SNIPPET

1910.106(h)(3)(iv)(b) Lightweight Walls and Roof

OSHA 1910 General Industry > H Hazardous Materials > 1910.106 Flammable Liquids > 1910.106(h) Processing Plants > 1910.106(h)(3) Processing Building > 1910.106(h)(3)(iv) Explosion Relief > 1910.106(h)(3)(iv)(b) Lightweight Walls and Roof

JUMP TO FULL CODE CHAPTER

Related Code Sections

1910.106(h)(3)(iv)(b) Hazardous Materials, Lightweight Walls and Roof

1910.110(b)(11)(iii)(c) Hazardous Materials,

exterior wall of lightweight construction ...

OSHA 1910 General Industry > H Hazardous Materials > 1910.110 Storage and Handling of Liquefied Petroleum Gases > 1910.110(b) Basic Rules > 1910.110(b)(11) Vaporizer and Housing > 1910.110(b)(11)(iii) > 1910.110(b)(11)(iii)(c)

1910.66(e)(3) Powered Platforms, Manlifts, and Vehicle-Mounted Work Platforms, Roof Guarding

perimeter guard shall not be more than six inches (152 mm) inboard of the inside face of a barrier, i.e. the parapet wall, or roof edge curb of the building ...

OSHA 1910 General Industry > F Powered Platforms, Manlifts, and Vehicle-Mounted Work Platforms > 1910.66 Powered Platforms for Building Maintenance > 1910.66(e) Powered Platform Installations-Affected Parts of Buildings > 1910.66(e)(3) Roof Guarding

1910.252(a)(2)(ix) Welding, Cutting, and Brazing, Combustible Walls

Where cutting or welding is done near walls, partitions, ceiling or roof of combustible construction, fire-resistant shields or guards shall ...

OSHA 1910 General Industry > Q Welding, Cutting, and Brazing > 1910.252 General Requirements > 1910.252(a) Fire Prevention and Protection > 1910.252(a)(2) Special Precautions > 1910.252(a)(2)(ix) Combustible Walls

1910.252(a)(2)(x) Welding, Cutting, and Brazing, Noncombustible Walls

If welding is to be done on a metal wall, partition, ceiling or roof, precautions shall be taken to prevent ignition of combustibles on the other ...