// CODE SNIPPET
220.127.116.11 Label Requirements
JUMP TO FULL CODE CHAPTER
Each over-the-road general-purpose vehicle powered by LP-Gas shall be identified with a weather-resistant, diamond-shaped label. [58:18.104.22.168]
The label shall be located on an exterior vertical or near vertical surface on the lower right rear of the vehicle (on the trunk lid of a vehicle so equipped but not on the bumper of any vehicle) inboard from any other markings. [58:22.214.171.124]
The label shall be a minimum of 43/4 in. (120 mm) long by 31/4 in. (83 mm) high. [58:126.96.36.199]
Related Code Sections
188.8.131.52 Refueling, Label Requirements
Each over-the-road general-purpose vehicle powered by LP-Gas shall be identified with a weather-resistant, diamond-shaped label. [ 58: 184.108.40.206 ...
Fire Code 2015 of Delaware > 42 Refueling > 42.11 Alternate Fuels > 42.11.2 Liquefied Petroleum Gas (LP-gas) > 220.127.116.11 Label Requirements
18.104.22.168 Compressed Gases and Cryogenic Fluids, Labeling Requirements
Individual compressed gas containers, cylinders, and tanks shall be marked or labeled in accordance with DOT requirements or those of the applicable ...
Fire Code 2015 of Delaware > 63 Compressed Gases and Cryogenic Fluids > 63.3 Compressed Gases > 63.3.1 General > 22.214.171.124 Labeling Requirements
(2) Special Equipment, Marking and Labeling Required
m (10 ft). Labels required by this section shall be suitable for the environment where they are installed ...
National Electrical Code 2020 of Delaware > 6 Special Equipment > 690 Solar Photovoltaic (PV) Systems > 690.31 Wiring Methods > (D) Direct-Current Circuits on or in Buildings > (2) Marking and Labeling Required
(3) Special Equipment, Marking and Labeling Required
SOURCE by means of permanently affixed labels or other approved permanent marking: Exposed raceways, cable trays, and other wiring methods Covers ...
National Electrical Code 2014 of Delaware > 6 Special Equipment > 690 Solar Photovoltaic (PV) Systems > 690.31 Methods Permitted > (G) Direct-Current Photovoltaic Source and Direct-Current Output Circuits on or Inside a Building > (3) Marking and Labeling Required
6.4.1 Heating, Ventilating, and Air Conditioning, Equipment Efficiencies, Verification, and Labeling Requirements
with the specified test procedure. Where multiple rating conditions or performance requirements are provided, the equipment shall satisfy all ...
2020 Delaware Commercial Building Energy Code > 6 Heating, Ventilating, and Air Conditioning > 6.4 Mandatory Provisions > 6.4.1 Equipment Efficiencies, Verification, and Labeling Requirements