// CODE SNIPPET
302.3.2 Joist Notching and Boring
JUMP TO FULL CODE CHAPTER
Notching at the ends of joists shall not exceed one-fourth the joist depth. Holes bored in joists shall not be within 2 inches (51 mm) of the top and bottom of the joist and their diameters shall not exceed one-third the depth of the member. Notches in the top or bottom of the joist shall not exceed one-sixth the depth and shall not be located in the middle one-third of the span.
Related Code Sections
302.3.2 General Regulations, Joist Notching and Boring
Notching at the ends of joists shall not exceed one-fourth the joist depth. Holes bored in joists shall not be within 2 inches (51 mm) of the top ...
Fuel Gas Code 2015 of Utah > 3 General Regulations > 302 (IFGC) Structural Safety > 302.3 Cutting, Notching and Boring in Wood Members > 302.3.2 Joist Notching and Boring
302.3.2 General Regulations, Joist Notching and Boring
Notching at the ends of joists shall not exceed one-fourth the joist depth. Holes bored in joists shall not be within 2 inches (51 mm) of the top ...
Fuel Gas Code 2018 of Utah > 3 General Regulations > 302 (IFGC) Structural Safety > 302.3 Cutting, Notching and Boring in Wood Members > 302.3.2 Joist Notching and Boring
R802.7 Roof-Ceiling Construction, Cutting, Drilling and Notching
Structural roof members shall not be cut, bored or notched in excess of the limitations specified in this section ...
Residential Code 2015 of Utah > 8 Roof-Ceiling Construction > R802 Wood Roof Framing > R802.7 Cutting, Drilling and Notching
302.3.1 General Regulations, Joist Notching
Notches on the ends of joists shall not exceed one-fourth the joist depth. Holes bored in joists shall not be within 2 inches (51 mm) of the top ...
Mechanical Code 2015 of Utah > 3 General Regulations > 302 Protection of Structure > 302.3 Cutting, Notching and Boring in Wood Framing > 302.3.1 Joist Notching
302.3.1 General Regulations, Joist Notching
Notches on the ends of joists shall not exceed one-fourth the joist depth. Holes bored in joists shall not be within 2 inches (51 mm) of the top ...
Mechanical Code 2018 of Utah > 3 General Regulations > 302 Protection of Structure > 302.3 Cutting, Notching and Boring in Wood Framing > 302.3.1 Joist Notching