// CODE SNIPPET
P3003.14 Joints Between Drainage Piping and Water Closets
Go To Full Code Chapter
Joints between drainage piping and water closets or similar fixtures shall be made by means of a closet flange or a waste connector and sealing gasket compatible with the drainage system material, securely fastened to a structurally firm base. The joint shall be bolted, with an approved gasket flange to fixture connection complying with ASME A112.4.3 or setting compound between the fixture and the closet flange or waste connector and sealing gasket. The waste connector and sealing gasket joint shall comply with the joint-tightness test of ASME A112.4.3 and shall be installed in accordance with the manufacturer's instructions.
Upcodes Diagrams
Related Code Sections
P3003.14 Sanitary Drainage, Joints Between Drainage Piping and Water Closets
Joints between drainage piping and water closets or similar fixtures shall be made by means of a closet flange or a waste connector and sealing ...
P3003.14 Sanitary Drainage, Joints Between Drainage Piping and Water Closets
Joints between drainage piping and water closets or similar fixtures shall be made by means of a closet flange or a waste connector and sealing ...
P3005.1.4 Sanitary Drainage, Water Closet Connection Between Flange and Pipe
One-quarter bends 3 inches (76 mm) in diameter shall be acceptable for water closet or similar connections, provided that a 4-inch by 3-inch (102 mm ...
P3005.1.4 Sanitary Drainage, Water Closet Connection Between Flange and Pipe
One-quarter bends 3 inches (76 mm) in diameter shall be acceptable for water closet or similar connections, provided that a 4-inch by 3-inch (102 mm ...
Section 705 Sanitary Drainage, Joints
only where a single joint is made between ABS and PVC pipes at the end of a building drainage pipe and the beginning of a building sewer pipe using ...