// CODE SNIPPET
2303.1.6.1 Jointing
JUMP TO FULL CODE CHAPTER
To ensure tight-fitting assemblies, edges shall be manufactured with square, shiplapped, beveled, tongue-and-groove or U-shaped joints.
Related Code Sections
1210.6 Hydronic Piping, Joints
Joints and connections shall be of an approved type. Joints and connections shall be tight for the pressure of the ground-source loop system. Joints ...
Mechanical Code 2015 of Pennsylvania > 12 Hydronic Piping > 1210 Plastic Pipe Ground-Source Heat Pump Loop Systems > 1210.6 Joints
1302.4.2 Nonpotable Water Systems, Joints
Collection piping conveying untreated water for reuse shall utilize joints approved for use with the distribution piping and appropriate ...
Plumbing Code 2015 of Pennsylvania > 13 Nonpotable Water Systems > 1302 On-Site Nonpotable Water Reuse Systems > 1302.4 Collection Pipe > 1302.4.2 Joints
1303.7.2 Nonpotable Water Systems, Joints
Collection piping conveying captured rainwater shall utilize joints approved for use with the distribution piping and appropriate for the intended ...
Plumbing Code 2015 of Pennsylvania > 13 Nonpotable Water Systems > 1303 Nonpotable Rainwater Collection and Distribution Systems > 1303.7 Collection Pipe > 1303.7.2 Joints
1403.2.1 Subsurface Landscape Irrigation Systems, Joints
Joints in distribution pipe shall be made in accordance with Section 705 of this code ...
Plumbing Code 2015 of Pennsylvania > 14 Subsurface Landscape Irrigation Systems > 1403 Installation > 1403.2 Distribution Piping > 1403.2.1 Joints
1405.12.5 Exterior Walls, Joints
Mitered joints shall not be used except where specifically approved for wide angles. Joints shall be uniformly buttered with an approved jointing ...
Building Code 2015 of Pennsylvania > 14 Exterior Walls > 1405 Installation of Wall Coverings > 1405.12 Glass Veneer > 1405.12.5 Joints