// CODE SNIPPET
303.1.2 Insulation Mark Ins
Related Code Sections
303.1.2 Climate Zones, Design Conditions, Materials, Equipment and Systems, Insulation Mark Ins
tallation. Insulating materials shall be installed such that the manufacturer's R -value mark is readily observable upon inspection ...
2010 Energy Conservation Code of NY > 3 Climate Zones, Design Conditions, Materials, Equipment and Systems > 303 Materials, Systems and Equipment > 303.1 Identification > 303.1.2 Insulation Mark Ins
E3307.3 General Requirements, Ungrounded Conductors
or gray insulation or a marking of three continuous white stripes is used for the supply to the switch but not as a return conductor from the switch ...
2010 Residential Code of NY > 33 General Requirements > E3307 Conductor and Terminal Identification > E3307.3 Ungrounded Conductors
250.114 Wiring and Protection, Equipment Connected by Cord and Plug
equivalent. Double insulated equipment shall be distinctively marked. In hazardous (classified) locations (see Articles 500 through 517) Where operated ...
National Electrical Code 2017 of New York State > 2 Wiring and Protection > 250 Grounding and Bonding > 250.114 Equipment Connected by Cord and Plug
366.120 Wiring Methods and Materials, Marking
Nonmetallic auxiliary gutters installed indoors shall be marked with the installed conductor insulation temperature rating ...
National Electrical Code 2017 of New York State > 3 Wiring Methods and Materials > 366 Auxiliary Gutters > 366.120 Marking
(3) Special Occupancies, Marking
All insulated low-voltage conductors shall be surface marked at intervals not greater than 1.2 m (4 ft) as follows: Listed conductors shall ...
National Electrical Code 2017 of New York State > 5 Special Occupancies > 552 Park Trailers > 552.10 Low-Voltage Systems > (B) Low-Voltage Wiring > (3) Marking