// CODE SNIPPET
69.3.11* Installation in Areas of Heavy Snowfall
JUMP TO FULL CODE CHAPTER
In areas where the ground snow load is equal to or exceeds 100 psf (488 kg/m2), piping, regulators, meters, and other equipment installed in the piping system shall be protected from the forces of accumulated snow. [58:6.18.1]
Related Code Sections
69.3.11* Liquefied Petroleum Gases and Liquefied Natural Gases, Installation in Areas of Heavy Snowfall
In areas where the ground snow load is equal to or exceeds 100 psf (488 kg/m 2 ), piping, regulators, meters, and other equipment installed ...
Fire Code 2018 of West Virginia > 69 Liquefied Petroleum Gases and Liquefied Natural Gases > 69.3 Installation of LP-gas Systems > 69.3.11* Installation in Areas of Heavy Snowfall
803.13.3 Interior Finishes, Heavy Timber Construction
Wall and ceiling finishes of all classes as permitted in this chapter that are installed directly against the wood decking or planking of Type IV ...
Building Code 2015 of West Virginia > 8 Interior Finishes > 803 Wall and Ceiling Finishes > 803.13 Application of Interior Finish Materials to Fire-Resistance-Rated or Noncombustible Building Elements > 803.13.3 Heavy Timber Construction
1607.7 Structural Design, Heavy Vehicle Loads
of the following loads:
The actual operational loads, including outrigger reactions and contact areas of the vehicles as stipulated and approved ...
Building Code 2015 of West Virginia > 16 Structural Design > 1607 Live Loads > 1607.7 Heavy Vehicle Loads
(B) Special Occupancies, Circuits Rated Greater Than 20 Amperes
Where only heavy-duty lampholders are used, such circuits shall be permitted to comply with Article 210 for circuits supplying heavy-duty lampholders ...
National Electrical Code 2017 of West Virginia > 5 Special Occupancies > 520 Theaters, Audience Areas of Motion Picture and Television Studios, Performance Areas, and Similar Locations > 520.41 Circuit Loads > (B) Circuits Rated Greater Than 20 Amperes
(E) Wiring and Protection, Heavy-Duty Lampholders
Outlets for heavy-duty lampholders shall be calculated at a minimum of 600 volt-amperes ...
National Electrical Code 2017 of West Virginia > 2 Wiring and Protection > 220 Branch-Circuit, Feeder, and Service Load Calculations > 220.14 Other Loads — All Occupancies > (E) Heavy-Duty Lampholders